Page is loading ...
Swim Jet Installation Instructions
Congratulations on the purchase of your new Balboa Water Group Swim Jet.
The Swim Jet provides you with a unit that will stimulate exercising, which
functions well when properly installed. The purpose of the Swim Jet is to provide
exercise in a small body of water.
The pool or spa should be a minimum of nine feet (9’) long and four feet (4’) wide
to provide a sufficient area for swimming. It will take a few trips in the water
before you become adept at staying in the main stream of the jets and pacing
yourself for the best exercise. The ideal position is approximately three feet (3’)
away and directly in front of the jets.
There are many ways you can exercise using your Swim Jet: on your back for the
back stroke, the side stroke, and if your pool is shallow, you can even try walking
or running.
Don’t be too anxious. Take your time to improve your swimming and the length
of time you work out.
40736 Rev A July 30, 2009
Swim Jet Schematic -- Installation Instructions
Side View - Jet & Suction
Top View - Jets
Top View - Jets & Suctions
Top View - Suctions
Air
Blower
(Optional)
1-1/2” H.P.
Pump
1-1/2” H.P.
Pump
2 Each: Part No. 16-5759 Swim Jet
2 Each: Part No. 10-6200 Main Drain
Pumps, Optimal Flow: 97 GPM @ 15 PSI
40736 Rev A July 30, 2009
/
