Worldwide Lighting W23101C4-BL Installation guide

Type
Installation guide

Worldwide Lighting W23101C4-BL The Worldwide lighting W23101C4-BL is a crystal chandelier with a height of 15 inches and a length of 23. Please read all instructions carefully before you proceed to install, make sure that the power supply is turned off and remains off until the installation is complete.

Each part has been assigned a number. Please proceed in a numerical order:

  1. Fix the Crossbar (01) with the junction box.
  2. Make sure the positive and negative charges of the wire and Lamp Body (02) match correctly, screw the connection point with the junction cap.
  3. Make sure the main wire is long enough and keep the rest of the wire in the 4” J-box.

Worldwide Lighting W23101C4-BL The Worldwide lighting W23101C4-BL is a crystal chandelier with a height of 15 inches and a length of 23. Please read all instructions carefully before you proceed to install, make sure that the power supply is turned off and remains off until the installation is complete.

Each part has been assigned a number. Please proceed in a numerical order:

  1. Fix the Crossbar (01) with the junction box.
  2. Make sure the positive and negative charges of the wire and Lamp Body (02) match correctly, screw the connection point with the junction cap.
  3. Make sure the main wire is long enough and keep the rest of the wire in the 4” J-box.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Worldwide Lighting W23101C4-BL Installation guide

Type
Installation guide

Worldwide Lighting W23101C4-BL The Worldwide lighting W23101C4-BL is a crystal chandelier with a height of 15 inches and a length of 23. Please read all instructions carefully before you proceed to install, make sure that the power supply is turned off and remains off until the installation is complete.

Each part has been assigned a number. Please proceed in a numerical order:

  1. Fix the Crossbar (01) with the junction box.
  2. Make sure the positive and negative charges of the wire and Lamp Body (02) match correctly, screw the connection point with the junction cap.
  3. Make sure the main wire is long enough and keep the rest of the wire in the 4” J-box.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI