LG WP-1690RWN Owner's manual

Brand: LG

Model: WP-1690RWN

Type: Owner's manual

LG WP-1690RWN is a washing machine with a range of features to make laundry day easier. It has a large capacity, so you can wash more clothes in one load, and it's energy-efficient, so you can save money on your utility bills. The machine also has a variety of wash cycles, so you can choose the right one for your clothes, and a built-in water heater, so you can wash your clothes in hot water if needed.

WP-1690RWN/ WP-1700RWN

WP-1800RWN/WP-1970RWN

To Clean the Filter

5.The washing machine is to be connected to the water mains using new hose-sets and old hose-sets

should not be reused.

3 4

5 6

1. Push the upper and lower part of the filter down and pull forward.

2. Open the lid and remove lint and then wash out.

4. Open the lid and remove lint and then wash out.

5. Close the lid and then insert the lower part of the overflow filter into the wash tub

and press down then press top part into position until you hear a click sound.

6. Replace the filter to the original position

3. Push the upper part of overflow filter down and pull forward.

*Warning - the appliance with two pronged plug must be grounded.

Do not connect the earth wire to the gas pipe, lightning arrester, telephone connecter, etc..

It is attached at the back of the washer. Connect it to the metal water pipe.

Install the earth wire to prevent short-circuit due to leaking current and electric shock.

If the water pipe is made of plastic, it does not have the earth effect.

Before connecting the power plug, check if the voltage setting of the washer matches the outlet voltage.

If AC outlet with ground terminal is used, grounding is not needed. if not, never forget earthing.

The appliance must be positioned so that the plug is accessible.

After connecting the earth wire

to the earth copper plate, bury

it at least 70cm deep under

earthing-only outlet.

Connecting to the When installing it in an area

where earthing is not possible,

purchase a short-circuit

breaker connect it to the outlet.

the wet ground.

Connect the drain hose to the outlet of the plunger valve located at the back side.

Be sure to reroute the hose so that it is not kinked, kinks or sharp

bending in the hose will prevent proper drainage.

Make sure water is drained smoothly by placing a base under the

machine or by applying other appropriate mean.

L <= 1 m.

For Non-Pump Model

For Pump Model

Insert the power plug into the outlet.

This washer is assembled for 220V, but can be changedfrom 220V to 110V ( or 127V).

Check your electrical source and follow the diagram below to convert voltage.

Push the clamp toward the body of the washing machine as shown in the figure.

Connecting the drain hose

Type of Fabric

Wash Amount of

Water

Level

Laundry (kg)

Amount of

Water (l)

Amount of

Detergent (g)

Selector

1.Look for a care label on your clothes. This will tell you about the fabric content of your garment

and how it should be washed.

2.Check all pockets to make sure that they are empty. Objects left in the pockets can damage both

your washer and your clothes. (could be cause the drain hose to clogg).

4.For you convenience hang up the wash cover on the right or left side of the washing machine tub

when not in use.

3.Sort clothes into loads that can be washed with the same wash cycle.

Sand

’

LG WP-1690RWN Owner's manual

LG WP-1690RWN Owner's manual

LG WP-1690RWN Owner's manual

Related papers