1
CAUTION...............WARNING...............IMPORTANT
USE ONLY PETERSON REAL FYRE BURNERS AND VALVES WITH THIS REAL FYRE LOG SET.
Important: Adequate ventilation is absolutely
necessary. Adequate spacing
between the logs is NECESSARY
and MUST be maintained. Some
carbon build up (sooting) may occur
where fl ames strike the logs. If carbon
build up (sooting) continues, rearrange
top logs to allow more opening(s) for
fl ame(s) before sooting becomes worse.
If any sooting occurs outside of the
fi rebox (i.e. on the walls), turn off unit
immediately and contact a qualifi ed
professional service technician.
This product is only warranted when used as part of
a Robert H. Peterson Co. vented burner system.
WARNING: Use ONLY Peterson Real Fyre burners
and valves with this Real Fyre gas log
set. Failure to do so may result in
property damage or personal injury,
and will void listings, certifi cations,
and invalidate claims made to RHP .
Contact your local Real Fyre dealer if you
need more information.
This instruction contains recommended log placement for these Real Fyre logs which will promote good
combustion and provide superior fl ame pattern and appearance. Use these logs only with a Peterson
burner system.
Adequate ventilation is absolutely necessary! Provided signifi cant, noticeable sooting does not occur,
some fl exibility is possible in log placement to suit your individual preference (see Important below). If you
experience a continued accumulation of black carbon (soot) on your logs it is an indication of incomplete
combustion and you should move the effected log(s) so as to minimize the fl ame contact on the effected
log(s). If signifi cant sooting continues, stop using this gas log set.
Please read these instructions completely and carefully.
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
LOG SET IMPORTANT INFORMATION
L-A2-411REV 1 - 1801150725
SHORELINE OAK LOG PLACEMENT INSTRUCTIONS
SO-24 shown
2
CAUTION: Burn hazard! Logs will remain hot for some time after use.
If you need to reposition any log to maintain the proper layout,
use heat resistant gloves or allow logs adequate time to cool
before handling.
Failure to use Peterson burners and valves may result in a DANGEROUS
situation and in property damage, personal injury or even death; will void
listings and certifi cations; and will void any insurance coverage by R.H.
Peterson Co or our insurers.
WARNING: This gas log set is for use with R.H. Peterson Co burners
(and parts) ONLY.
L-A2-411
REV 1 - 1801150725
All items for this log set are included in one (1) box.
Log set shown on a P45 Series Burner System.
Sand and/or vermiculite (included with your
burner system) must be poured into the burner
pan prior to ember and log placement. Refer
to the main owner’s manual for sand and/or
vermiculite placement. Then follow the steps
below for glowing ember and log placement.
3
Shoreline Oak Log Placement Instructions (18" model)
CAUTION: Burn hazard! Logs will remain
hot for some time after use.
1
2
3
4
Final Log Placement
SO-18
PARTS LIST
3
8
2
7
5
1
IV
I
II
III
CHDSL-12
CHDSL-16
CHAOL-10T
CHDSL-10
CHDSL-14
4
6
9
CHDSL-10
CHDSL-12
6
PNL-15T
CHDSL-9
10
CHDSL-9
5
EM-1
111
1
1
1
1
1
1
1
I
No embers beyond
pan divider (P45 burner
systems only)
1
V
7
8
9
10
Place glowing embers
EM-11
Place
bryte
coals
Place logs then separate the bryte coals into
small pieces and evenly place them over the
glowing embers in the area shown.
Bryte coals
Glowing embers
4
Shoreline Oak Log Placement Instructions (24" model)
SO-24
PARTS LIST
4
10
2
11
9
CHDSL-12
CHDSL-16
CHDSL-15
CHAOL-10T
CHDSL-10
CHDSL-14
5
CHDSL-10
CHDSL-12
8
PNL-15T
CHDSL-9
CHDSL-9
CHAOL-10T
7
3
1
6
EM-1
All items for this log set are included in one (1) box.
CAUTION: Burn hazard! Logs will remain
hot for some time after use.
2
1
7
Final Log Placement
9
IV
I
II
III
8
3
V
10
11
12
12
Log set shown on a P45 Series Burner System.
Sand and/or vermiculite (included with your
burner system) must be poured into the burner
pan prior to ember and log placement. Refer
to the main owner’s manual for sand and/or
vermiculite placement. Then follow the steps
below for glowing ember and log placement.
Place glowing embers
No embers beyond
pan divider (P45 burner
systems only)
4
5
6
EM-11
Place logs then separate the bryte coals into
small pieces and evenly place them over the
glowing embers in the area shown.
Bryte coals
Glowing embers
Place
bryte
coals
5
Shoreline Oak Log Placement Instructions (30" model)
SO-30
PARTS LIST
5
14
2
8
CHDSL-12
CHDSL-15
CHAOL-10T
CHDSL-10
CHDSL-14
11
CHDSL-9
13
CHDSL-12
12
PNL-15T
CHDSL-10
15
CHDSL-9
CHAOL-10T
10
4
1
CHDSL-16
3
CHDSL-14
6
PNL-15T
OCBWL-9
7
9
EM-1 (2 bags)
5
4
7
Final Log Placement
9
V
III IV
8
6
VI
13
15
14
2
3
II
1
10
11
12
All items for this log set are included in one (1) box.
CAUTION: Burn hazard! Logs will remain
hot for some time after use.
I
Log set shown on a P45 Series Burner System.
Sand and/or vermiculite (included with your
burner system) must be poured into the burner
pan prior to ember and log placement. Refer
to the main owner’s manual for sand and/or
vermiculite placement. Then follow the steps
below for glowing ember and log placement.
For P45, only use 1½ bags of embers. Store
any excess embers in a safe location.
Place glowing embers
No embers beyond
pan divider (P45 burner
systems only)
EM-11
Place logs then separate the bryte coals into
small pieces and evenly place them over the
glowing embers in the area shown.
Bryte coals
Glowing embers
Place
bryte
coals
6
NOTES PAGE
Please use this page to record any information that you may want to have at hand.
-
1
-
2
-
3
-
4
-
5
-
6
Real Fyre Shoreline Oak Log Owner's manual
- Type
- Owner's manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Real Fyre Shoreline Driftwood Owner's manual
-
-
-
-
-
-
-
-
-