Signature Hardware SH433238 Installation guide

Signature Hardware
Brand
Signature Hardware
Model
SH433238
Type
Installation guide

This manual is also suitable for

COOPER TUB SPOUT INSTALLATION
GETTING STARTED
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing plumbing fixtures. Signature
Hardware accepts no liability for any damage to the
plumbing, floor, walls, tub, or for personal injury during
installation.
Observe all local plumbing and building codes.
Unpack and inspect the item for shipping damage. If any
damage is found, contact our Customer Relations team
at 1-866-855-2284.
Ensure that you have gathered all the required
materials that are needed for the installation.
For the following installation instructions, it is
assumed that the finished wall has been completed
and a valve is already installed.
Before you begin, the main water supply to your home
should be shut off.
TOOLS AND MATERIALS:
Plumbers
Tape
Adjustable
Wrench
1Cooper Tub Spout Installation Instructions
Tape Measure
Hex Wrench
SKU(s): 940970
COOPER TUB SPOUT INSTALLATION
INSTALLATION
3. Remove the two screws located on the back of the
tub spout, as shown.
1. To prepare for installation, a female inlet should be
installed at the desired installation location.
2. Loosen the set screw on the bottom of the spout
and remove the nipple from the back of the tub spout,
as shown.
2Cooper Tub Spout Installation Instructions
4. Secure the backplate to the back of the tub spout
using the screws that were removed in step 3. Tighten
firmly.
spout
nipple
set screw
screws
backplate
female inlet
COOPER TUB SPOUT INSTALLATION
7. Once the spout is in place and properly aligned,
secure the spout by tightening the set screw under-
neath, as shown.
5. Apply plumber’s tape or thread sealant to the
threads of the nipple. Screw the nipple into the
prepared female inlet. Tighten firmly using an adjust-
able wrench.
3Cooper Tub Spout Installation Instructions
6. Connect the tub spout to the installed nipple. Push
firmly into place. Ensure that the spout is aligned
straight.
8. Once installation is complete, turn the water supply
on to ensure that the spout is properly functioning.
Check for any leaks.
plumber’s tape
female inlet
  • Page 1 1
  • Page 2 2
  • Page 3 3

Signature Hardware SH433238 Installation guide

Signature Hardware
Brand
Signature Hardware
Model
SH433238
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents