Minka Group 4665-598 User manual

Brand: Minka Group

Model: 4665-598

Type: User manual

Minka Group 4665-598: This fixture is designed to provide ample lighting for any room in your home. With its easy-to-follow installation instructions, you'll be able to mount it on the wall or ceiling in no time. The fixture comes with all the necessary hardware, including plastic anchors and wood screws, so you can get it up and running quickly and easily.

Once installed, the fixture can be used to create a variety of lighting effects. The included T8 bulbs provide bright, even illumination, while the glass drops add a touch of elegance. You can also adjust the height of the fixture to create the perfect ambiance for any occasion.

INSTALLATION INSTRUCTION FOR FIXTURE #4665-598

MOUNTING THE FIXTURE (FIG. 1)

1. Shut off the power supply at the fuse box or circuit

breaker. If necessary, r

emove the old fixture from wall.

Including the mounting hardware.

2. Carefully remove the new fixture from the carton and

check that all parts are included as shown in the

illustration.

3. Lift mounting plate (B) to outlet box so that the screw

holes in outlet box line up with slots on mounting plate

(B), mark spots at outer keyholes for the plastic

anchors (A) to be installed.

4. Drill pilot holes on spots marked and insert plastic

anchors (A). (If fastening with wood screws to stud,

ignore this step)

5. Attach mounting plate (B) to outlet box using the

outlet box screws (D) (SIZE: #8-32N * L0.5”).

6. Attach ends of mounting plate (B) to plastic anchors

(A) or the spots that you marked on stud and secure

with four wood screws (C).

The support cable is provided to support the weight of

the fixture while wiring. Align the fixture to mounting

plate (B) and attach hook (K)

on the end of support

cable (L) into a slot located on mounting plate (B).

Carefully allow the support cable (L) to support the

weight of the fixture while wiring.

CONNECTING THE WIRES (FIG. 2)

8. At this point, connect the electrical wires as shown in

Fig. 2, making sure that all wire nuts are secured. If

your outlet box has a ground wire (green or bare

copper), connect the fixture’s ground wire to it.

Otherwise, connect the fixture’s ground wire directly to

the mounting plate (B) using the green ground screw

provided.

9. Tuck the wire connections neatly into the wall outlet

box.

ASSEMBLE THE FIXTURE (FIG. 1)

10. Attach the backplate (E) onto the outlet box and

secure with four mounting screws (F).

11. Attach the glass drops (J) to the hooks (I).

12. Install the T8 bulbs (G) (bulbs included) into the

sockets (H).

(DO NOT EXCEED THE MAXIMUM WATTAGE

RATING!) (NE PAS DEPASSER LA PUISSANCE

NOMINALE MAXIMALE!).

Your installation is now complete. Return power to the

junction box and test the fixture.

Min 90

℃

supply conductors.

Fig.1

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig.2

Minka Group 4665-598 User manual

Minka Group 4665-598 User manual

Minka Group 4665-598 User manual

Related papers

Other documents