FOR USE WITH E SERIES ELECTRIC FURNACE COIL CABINETS 904067 OR 904157
ELECTRIC FURNACE DOWNFLOW COIL CABINET
IMPORTANT SAFETY INFORMATION
Please read all instructions before installing this equipment.
Pay attention to all safety warnings and any other special notes
highlighted in the manual. Safety markings are used frequently
throughout these instructions to designate a degree or level of
seriousness and should not be ignored.
WARNING - Indicates a potentially hazardous situation that if
not avoided, could result in personal injury or death.
CAUTION - Indicates a potentially hazardous situation that if
not avoided, may result in minor or moderate injury or property
damage.
These instructions are primarily intended to assist qualified
individuals experienced in the proper installation of this appliance.
Some local codes require licensed installation/ service personnel
for this type of equipment.
WARNING:
This kit is to be installed by a qualified service
technician in accordance with these instructions and
all codes having jurisdiction. Failure to follow these
instructions could result in serious injury, property
damage, or death.
WARNING:
To avoid risk of electric shock, personal injury, or
death, disconnect electrical power to the unit before
performing any maintenance or service. The unit may
have more than one electric power supply.
COIL CABINET INSTALLATION
Before installing the coil cabinet, consider all clearances for the
installation and future servicing of the furnace. NOTE: There are
two filters in the assembled downflow coil box. One is a 20” x 25”
filter located behind the grille. The other is a 16” x 20” filter located
in the top of the coil box. Both of these filters are disposable and
should be checked and/or replaced once per month or as often
as necessary.
1. Install the furnace in accordance to the installation instructions
provided with the unit.
2. If VentilAire is installed on the furnace, remove the duct
connector from the E series furnace and cover the hole with
metal tape or sheet metal.
3. Position the coil cabinet on a flat surface. Remove the 20” x
25” filter and the louvered grille. See Figure 1 (page 2).
4. Remove the 16” x 20” filter from the E Series furnace.
NOTE: The filter retainer from the furnace can be discarded.
Place this filter into the filter retainer supplied with the downflow
coil cabinet. This will filter the air from the VentilAire and the
top opening for 5 ton applications.
5. Install the VentilAire duct to the top of the coil box at the
location shown in Figure 1.
6. Place the coil box on top of the furnace (with the grille and 20”
x 25” filter removed from the coil box assembly) and secure
it to the furnace with the provided screws.
7. Install the indoor coil per the instructions with the coil.
8. Install the 20” x 25” filter in the assembly.
9. Install the louvered grille in the door bracket and attach to the
top of the cabinet with the pawl latch.
INSTALLATION INSTRUCTIONS
INSTALLER: PLEASE LEAVE THESE INSTALLATION INSTRUCTIONS WITH THE EQUIPMENT OWNER
708391A (Replaces 7083910)
Electric
Furnace
Coil Box
Wrapper
Filter
Retainer
Coil Box
To p
Side Filter
Brackets
To p Filter
Bracket
Ventilaire
Attachment
Location
Louvers not
necessary with
ducted return
air furnace
Two-Piece Door
For use with Coil
Cabinet P/N 904067
One-Piece Door
For use with Coil
Cabinet P/N 904157
Figure 1. E Series Downflow Coil Cabinet
Specifications & illustrations subject to change without notice or incurring obligations (06/15).
O’Fallon, MO, © Nortek Global HVAC LLC 2015. All Rights Reserved.
-
1
-
2
Miller E2/E3 Coil Furnace Cabinet Kit Single Pack Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Broan E2/E3 Coil Furnace Cabinet Kit Single Pack Installation guide
-
Broan E5 Series Electric Furnace Installation guide
-
-
Broan Downflow Coil Box Electric Furnaces Installation guide
-
COMFORT-AIRE E7EM-010H1 Installation guide
-
Broan E4EB Series Electric Furnace Installation guide
-
Broan E3EX-020 Installation guide
-
-
-