Page is loading ...
Power Cord Retention Clip
Installation Guide
Package Contents
(For IEC Type PDUs)
Power Cord Retenon Clip Installaon
Removing the Power Cord Retenon Clip
Inlet Power Cord Retenon Cable
Clip Installaon
(For 1U Model)
The accessories inside this package are
for specific use and should only be used
with the bundled PDU. Do not use these
accessories with other PDUs.
(M3x4) Screws (4 for 8 Outlets, 8 for 16 Outlets,
and 12 for 24 Outlets)
Power Cord Retention Cable Clips (12 for 8 Outlets,
24 for 16 Outlets, and 36 for 24 Outlets)
Cable Ties (12 for 8 Outlets, 24 for 16 Outlets,
and 36 for 24 Outlets)
Step 1. Remove the screw below the outlet where the
Power Cord Retention Cable Clip will be installed.
Step 2. Attach the Cable Tie on the PDU and secure it
with the removed screw in the previous step.
Step 3. Place a Power Cord Retention Cable Clip on the
power cord. Align and Insert the Cable Tie into
the Cable Clip as shown in the figure below.
Step 4. Push the Power Cord Retention Cable Clip until it
touches the plug and fasten the Retention Cable
Clip like the figure below.
Step 1. Attach the Cable Tie on the PDU and secure it
with the attached screw.
Step 2. Place a Power Cord Retention Cable Clip on the
power cord. Align and Insert the Cable Tie into
the Cable Clip as shown in the figure below.
Step 1. To remove the Power Cord Retention Clip by
pushing it to the right as shown in the figure below.
Step 3. Push the Power Cord Retention Cable Clip until it
touches the plug and fasten the Retention Cable
Clip like the figure below.
Step 2. Remove the Power Cord Retention Clip by pulling
the clip (show in the image below) to the left.
CAUTION!!
K09-0000122-01
/