FMI SVYD18PR Operating instructions

FMI
Brand
FMI
Model
SVYD18PR
Type
Operating instructions

This manual is also suitable for

CAST IRON STOVE RETRO FIT KIT
INSTRUCTION SHEET
Required for Oxford™ Stoves and Victor Hearth
®
Stoves Using Models SVYD18NR and
SVYD18PR Remote-Ready Gas Log Heaters (Burner System For Cast Iron Stoves)
ITEMS INCLUDED IN KIT
• Stove Back - 111532-01
• Stove Bottom - 111531-02
• Hardware Kit - 104177-03
STOVE CAVITY ASSEMBLY
1. Assemble the cast iron stove as shown in Stove Cavity Assembly
in the owner’s manual. Disregard the steps for attaching stove bot-
tom, installing gas log heater, and fastening back panel.
2. Remove packing inserts, parts, and hardware for this kit from box.
3. Using the four metal screws from the hardware kit, attach gas log
heater to pan as shown in Figure 1.
4. Using the two 3/4" bolts and two flat washers, attach gas log heater
and pan to inside chamber of cast iron stove as shown in Figure 1.
Figure 9 - Attaching Stove Pan (Oxford™ Model Shown)
Metal Screws
3/4" Bolts
Washers
Stove Pan
INSTALLING GAS LOG INTO STOVE
1. Remove log from carton.
2. Remove all protective packaging applied to log for shipment.
3. Check log for any shipping damage. If damaged (pieces larger
than the size of a dime), promptly inform dealer where you bought
heater.
4. Set one-piece log on heater base as shown in Figure 2. Make sure
middle section at bottom of log is seated into "U" shaped cutout in
center of heater base. Log will fit securely on base.
IMPORTANT:
Make sure log does not cover any burner ports
and does not touch the stove cavity (see Figure 3).
5. Fasten back panel from retro fit kit to stove with four flat washers
and 1/2" bolts from hardware kit.
H
I
L
O
O
F
F
P
I
L
O
T
O
N
One-Piece
Log Set
"U" Shaped Cutout in Chassis
Burner
Middle
Section at
Bottom of
Log Set
Figure 2 - Installing One-Piece Stove Log Set
Heater Base
enings)
2701 Industrial Drive
Bowling Green, KY 42101
www.desatech.com
113199 01
NOT A UPC
113199-01
Rev. A
04/04
6. Place freestanding stove in desired position in room. Be sure to
maintain clearances to combustibles as outlined in the owner’s
manual.
7. Continue installation as shown in owner’s manual, Connecting to
Gas Supply.
Burner Porting Areas
(double slotted
rectangular openings)
Figure 3 - Top View of One-Piece Log Set on Gas Log
Heater
Safety Pilot Location
One-Piece
Log Set
  • Page 1 1

FMI SVYD18PR Operating instructions

FMI
Brand
FMI
Model
SVYD18PR
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents