3
NOTE: The Bluetooth
®
word mark and logos are registered trademarks owned by the
Bluetooth
®
, SIG, Inc. and any use of such marks by DeWALT is under license. Other
trademarks and trade names are those of their respective owners.
RSS standard(s). Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE:
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and speaker.
speaker is connected.
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
gain should be so chosen that the equivalent isotropically radiated (e.i.r.p.) is not more
than that necessary for successful communication.
the antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.
WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to
WARNING: To prevent electric shock, match wide blade of plug to wide slot fully insert.
Do not disassemble speaker. Take it to an authorized service center when service
or repair is required. Incorrect reassembly may result in a risk of electric shock,
electrocution or fire.
Disconnect the speaker from the outlet before attempting any cleaning. This will
reduce the risk of electric shock. Removing the battery pack will not reduce this risk.
PORTER-
battery packs. Do not use any other voltage. Only use adapter provided.
The label on your tool may include the following symbols. The symbols and their definitions
are as follows:
V ..................volts A ...................amperes
Hz ................hertz W .................. watts
min ..............minutes
or AC .......alternating current
or DC ...direct current
n
o .................no load speed
................Class I Construction .................earthing terminal
(grounded)
................safety alert symbol
................Class II Construction .../min or rpm...revolutions or
(double insulated) reciprocation per minute
...............shock hazard symbol NBC ............ no battery connection