Epson PowerLite D6150 Installation Handbook
- Category
- Projector lamps
- Type
- Installation Handbook
This manual is also suitable for
INSTALLATION
HANDBOOK
Maintenance
Epson PowerLite D6150 /
D6155W / D6250
1
Projector Lamp Maintenance
The projector keeps track of the number of hours the lamp is used and displays this information in the
projector's menu system.
Replace the lamp as soon as possible when the following occurs:
• The projected image gets darker or starts to deteriorate
• A message appears when you turn on the projector telling you to replace the lamp
• The projector's lamp light is flashing orange
Replacing the Lamp
Before you replace the lamp, let the projector cool down for at least one hour.
Warning: Let the lamp fully cool before replacing it to avoid injury.
You can replace the lamp while the projector is mounted to the ceiling, if necessary.
1. Turn off the projector and unplug the power cord.
2. Allow the projector lamp to cool down for at least one hour.
3. Use the screwdriver included with the replacement lamp to loosen the screw securing
the lamp
cover.
Warning: If the lamp is broken, glass fragments may be loose inside the lamp chamber. Be careful
removing any broken glass to avoid injury.
4. Slide the lamp cover out and lift it off.
INSTALLATION
HANDBOOK
Maintenance
Epson PowerLite D6150 /
D6155W / D6250
2
5. Loosen the screws securing the lamp to the projector. The screws do not come all the way out.
6. Lift up the lamp handle and gently pull the lamp out of the projector.
Note: The lamp(s) in this product contain mercury. Please consult your state and local
regulations regarding disposal or recycling. Do not put in the trash.
7. Gently insert the new lamp into the projector. If it does not fit easily, make sure it is facing the right
way. Press the handle down.
Caution: Do not touch any glass on the lamp assembly to avoid premature lamp failure.
INSTALLATION
HANDBOOK
Maintenance
Epson PowerLite D6150 /
D6155W / D6250
3
8. Push in the lamp firmly and tighten the screws to secure it.
9. Replace the lamp cover and tighten the screw to secure it.
Note: Be sure the lamp cover is securely installed or the lamp will not come on.
Reset the lamp timer to zero to keep track of the new lamp’s usage.
Resetting the Lamp Timer
You must reset the lamp timer after replacing the projector's lamp to clear the lamp replacement
message and to keep track of lamp usage correctly.
Note: Do not reset the lamp timer if you have not replaced the lamp to avoid inaccurate lamp usage
information.
1. Turn on the projector.
2. Press the Menu button.
3. Select the Reset menu and press Enter.
INSTALLATION
HANDBOOK
Maintenance
Epson PowerLite D6150 /
D6155W / D6250
4
4. Select Reset Lamp Hours and press Enter.
You see a prompt asking if you want to reset the lamp hours.
5. Select Yes and press Enter.
6. Press Menu to exit the menus.
-
1
-
2
-
3
-
4
Epson PowerLite D6150 Installation Handbook
- Category
- Projector lamps
- Type
- Installation Handbook
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI