Dyconn Faucet DF-K81ZA Installation guide

Type
Installation guide
Thank you for purchasing our product. Please read this manual before installation and use to ensure that your product
will function at peak performance.
Read this manual thoroughly and store in a safe place for future references.
NIARA: Intelligent Toilet
Model: DF-K81ZA
Product Manual
NIARA
Dyconn Faucet
19224 E Walnut Drive N., Suite #G
City of Industry, CA, 91748
TEL: 626-768-2849
FAX: 626-333-8575
Contents
Kick control Radar sensor
New features to oer you an enjoyable experience
User Friendly Design
Before use Functions troubleshooting Others
Dyconn Faucet
NIARA
User Friendly Side Control Panel
(Refer to page 13)
Radar Sensor
Auto open lid/seat
when user approaches
Kick open lid
Hands odesign
Foot-touch control
1
1
2
15
15
15
2
3
9
7
8
4
17
18
18
17
17
18
18
20
16
19
18
6
Parts Information
Overview
Remote Control
Design Overview
Safety Information
Warnings
Attention
Installation
Before you Install
Installing Your Product
Maintenance
Surface Cleaning
Filter Maintenance
Nozzle Maintenance
Troubleshooting
Power button
Wash functions
Dryer
Heated Seat
Remote Control
Toilet Unit
Soft-Closing Feature
Specications
Warranty Information
The functions may vary from dierent part no.
Features
Remote control
Limitless wash
Posterior wash
Front wash
Aerated wash
Auto wash
Oscillating
Cold/warm massage
3D massage
Water pressure adjustment
Water temp. adjustment
Wand position adjustment
Self-cleaning Nozzle
Nozzle sterlization
Heated seat
Warm air dryer
Deodorization
Enema wash
Automated seat
Automated lid
Kick controlled seat/lid
Auto open/close sensor
Soft-closing lid/seat
Seat Temp. Adjustment
Dryer Temp. Adjustment
Night Light
Instant Heating
Energy-Saving Setting
Blackout Flush
Remote Control Flush
Auto Flush
Dryer Flush
Kick Flush
Occupied Sensor
Filtered Water
Air Segregation
Anti-backow
Travel Model
Easy to Clean Glaze
Side control panel
8 Protections
Nano anti-bacterial
Cleaning
Remote
Comfort
Convenience
Safety
Functions
Part no.
K81 Series
Kick control
Radar Sensor 3D massage
Wax
Please conrm all the aforementioned items are inside the package. If anything is missing,
please contact our customer service at 626-855-1700
Illustrations above are for references only,. Actual objects may look dierent in person
We provide you with 2 pcs of conversion nut, each dierent versions. Please select according
to your plumbing requirements.
Grounded power outlet
1. Install the washer and bolts to the flange.
2. Place the flange on to the drain hole and
ensure the bolts are properly aligned with
the centerline. Then mark the location of
sections 1,2,3,4 with a marker as illustrated.
4. Place the flange onto the drain hole again
and tigten the four screws into the ground,
when the bolts are aligned with the centerline.
Water supply
Water supply
Attach the ush water hose to the T-valve and tighten.
Attach the clean water hose to the T-valve and tighten.
Connect the T-valve to the water supply and tighten.
Use gasket to prevent water leakage.
insert the anchors into the
hole and coat sealant on the edge of the
drain using a silicon gun.
Note: After 24 hours, product will automatically go into power saving mode and
Side Control Panel.
Cut o the power and water supply before maintenance.
Direct water wash to the entire product is prohibited.
A wet soft brush, cloth or sponge may be used to clean the ceramic area
Wipe dust or stains with a soft wet cloth
Do not use abrasive cleaning solutions, such as alcohol, bleach, paint thinner, cresol,
benzene, gasoline, etc.
Please clean or replace the filter according to your local water
situation to ensure a healthy water source
When the water pressure is low, please clean or replace the
filter. Please make sure the water supply is turned off before
removing. Fasten the filter to avoid leakage.
Do not spray water or
detergents on the toilet,
remote control or the
power cord. Doing so may
cause electrick shock or fire.
Maintenance during Winter Season
During winter season, the water inside may
freeze after long periods of storage and
non-usage. Please take measures to prevent.
Press the "Nozzle Clean"" button on
the remote control without occupying
the seat. The nozzle will extend.
Proceed to clean with a soft toothbrush.
Before connecting the product to the water
supply and electrical outlet, allow it to defrost
for 30 mins in a warm indoor environment.
In cases of extreme cold/freezing/nozzle
stuck in place, wrap the water input line with
a warm towel. Never pour hot water or use a
hot dryer directly on the toilet.
Do not forcefully hold the nozzle,
otherwise it may break.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

Dyconn Faucet DF-K81ZA Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI