Stahls Hotronix Fusion XF Replacement Manual

  • Hello! I am an AI chatbot trained to assist you with the Stahls Hotronix Fusion XF Replacement Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Fusion (Model XF)
Power Switch Replacement
2015-10-27
Technical Assistance: 1-(800)-727-8520
Manuals: hotronix.com/heat-press-manuals Page 1 of 4
Included Parts:
1. Power Switch
Required Tools:
2. Allen Wrenches (3/32” & 9/32”)
CAUTION: Detach power cord before
proceeding
Lower heater but do not lock into place, such
that it rests gently on lower platen
1
2
Fusion (Model XF)
Power Switch Replacement
2015-10-27
Technical Assistance: 1-(800)-727-8520
Manuals: hotronix.com/heat-press-manuals Page 2 of 4
Loosen set screw in shaft of pressure
adjustment knob and remove knob
Remove 4 #8-32 x ½” Thumb Screws (right
2 shown) from underside of control housing
using 9/32” Allen Wrench
Lift off control housing and lay it gently on
left side of press
Squeeze retaining clips together to release
switch from housing
Fusion (Model XF)
Power Switch Replacement
2015-10-27
Technical Assistance: 1-(800)-727-8520
Manuals: hotronix.com/heat-press-manuals Page 3 of 4
Transfer wires from old Power Switch to
new, one at a time to ensure each wire
attaches to the correct terminal
Install new Power Switch into housing and
confirm that wiring is correct as shown
Replace housing onto press and insert 4
#8-32 x ½” Thumb Screws (right 2 shown),
tightening with 9/32” Allen Wrench
Fusion (Model XF)
Power Switch Replacement
2015-10-27
Technical Assistance: 1-(800)-727-8520
Manuals: hotronix.com/heat-press-manuals Page 4 of 4
Replace Pressure Adjustment Knob, aligning
set screw with flat of shaft and tightening
with 3/32” Allen Wrench
Raise handle into open position, plug in
press and turn ON to verify proper operation
/