LP387

Luxpro LP387 User manual

  • Hello! I've reviewed the user manual for the LUX PRO LP387 work light. This manual provides instructions on how to use the light, including charging, mode selection and also covers its features such as its 360-degree swivel, magnetic base, and IPX4 waterproof rating. I'm ready to assist with any questions you have about this device.
  • How do I turn the light on and off?
    How do I cycle through the light modes?
    How do I charge the work light?
    How long does it take to charge?
USER MANUAL
Operation Instructions
Rugged-durable design
Strong magnet base
360° swivel capabilities
Rechargeable 2300mAh battery (USB cable included)
Battery indicator lights
IPX4 waterproof rating
Features
14725 S Porter Rockwell Blvd Ste C
Bluffdale, UT 84065
luxpro.com
866.553.8886
Charging Instructions
Rechargeable 360° Swivel
LEDWork Light
LP387
Magnetic
USB
Rechargeable
The LP387 has a Limited 90-Day Warranty Against Manufacturers
Defects from time of purchase.
For warranty claims please contact us by calling 801-553-8886 or
sending an email to info@simpleproducts.com
Product Warranty
Medium
High
ANSI/PLATO FL1 STANDARD
500 lm
1000 lm
LUMENSMODES
4h
2h
RUN TIME
30m
40m
BEAM
DISTANCE
Low 250 lm 6h 20m
On/O: Press and release the button on the top of the light to
turn on and o.
Cycle Modes: Press and release the button on the top of the light
repeatedly to cycle through modes (High/Medium/Low).
The LP385 uses a Lithium 3.96V, 2300mAh rechargeable battery.
To charge the work light, rst reveal the charge port by lifting the
rubber dust cover on the top of the light.
Green battery indicator lights on the front of the light will
start blinking to indicate the light is charging. The work light is
fully charged one the indicator lights are no longer blinking.
Rechargeable battery is sealed, and replacement is not necessary.
The LP387 has a charge time of approximately 6 hours.
Replace batteries at 25% to avoid
complete loss of usability
Green LED Battery
Indicators
Plug the small end of the Micro-USB charging cable (included)
into the port on the work light. Plug the opposite end of the
charging cable into a 5V USB power source.
/