2. Ninja
  3. CFN600 Series

Ninja CFN600 Series User manual

  • Hello! I am a chat assistant that has analyzed the document provided. This document contains cleaning cycle instructions for the Ninja CFN600Series Espresso & Coffee Barista machine. It covers both the capsule and grounds cleaning cycles which use descaling solution or white vinegar. I'm ready to answer your questions about the cleaning process and its specific steps.
  • When should I run a capsule clean cycle?
    How long does the capsule clean cycle take?
    How long does the grounds clean cycle take?
    What should I use for the cleaning solution?
    When should I run the grounds clean cycle?
CAPSULE CLEAN CYCLE - Will take 2 hours to complete.
1. Ensure the lever is closed
and no capsule is inserted.
Remove the Adjustable
Cup Tray from the brewer.
2. Place the Capsule Clean Cycle
Platform on the front right
base of the unit so that it sits
on the countertop below the
capsules spout.
.
3. Remove the lid from the carafe
and place the carafe on the
Capsule Clean Cycle Platform.
*Descaling solution is available from ninjakitchen.com. Follow your solution’s recommended concentration level.
**Fill the water reservoir to the Travel Mug line (16 oz.) with white vinegar, then add water to the Full line.
†CAUTION: DO NOT immerse coee maker in any liquid.
© 2022 SharkNinja Operating LLC
4. Fill the reservoir
to the Full line with
descaling solution*
and water or white
vinegar** and water.
5. Once the water
reservoir is filled,
press the Capsule
Button and then press
the Clean button.
6. Press START BREW.
A 2-hour countdown
will begin on clock
display.
7. Upon completion
the brewer will beep
and display “End”.
Clean the reservoir
and carafe. Flush the
system by running
three water-only
Lungo brews.
Capsule
Clean
Cycle
Platform
When to run a capsule clean cycle:
If typical capsules you brew are taking significantly longer time to brew, run a capsule clean cycle.
If the clock is displaying “Add Wtr”, ensure the water tank is filled and fully seated, then try again.
If “Add Wtr” persists, try running a water-only brew with the lever closed. If “Add Wtr” still persists,
run a capsule clean cycle.
SAVE FOR LATER USE
NINJA® ESPRESSO & COFFEE BARISTA
SYSTEM CLEAN CYCLE INSTRUCTIONS
How often to run a grounds clean cycle:
When the Intelligent Clean Cycle Indicator under the Grounds Button illuminates orange, run a grounds
clean cycle.
1. Place the empty
carafe beneath the
brew basket.
2. Fill the reservoir to the Full line with
either descaling solution* and water
or white vinegar** and water.
3. Once the water
reservoir is filled,
press the Grounds
Button and then press
the Clean button.
4. Press START BREW.
Countdown will begin
on clock display.
*Descaling solution is available from ninjakitchen.com. Follow your solution’s recommended concentration level.
**Fill the water reservoir to the Travel Mug line (16 oz.) with white vinegar, then add water to the Full line.
†CAUTION: DO NOT immerse coee maker in any liquid.
CFN600Series_Insert_CleanCycle_REV_Mv2
5. Upon completion the brewer will beep and
display “End”. Empty the carafe and place
it back under the brew basket. Clean the
reservoir and fill with fresh water up to the
Full line. Now, flush the system by running
a water-only Full Carafe Classic brew.
Please make sure to read the enclosed Ninja® Owner’s Guide prior to using your unit.
SAVE FOR LATER USE
NINJA® ESPRESSO & COFFEE BARISTA
SYSTEM CLEAN CYCLE INSTRUCTIONS
GROUNDS CLEAN CYCLE - Will take 75 minutes to complete.
/