K&N VF2064, 99-6000 Installation guide

I've reviewed the provided document which details the cleaning instructions for the K&N Cabin Air Filter. The document outlines a 6-step process for removing, cleaning, rinsing, and refreshing the filter within a certain timeframe. I'm ready to answer your questions regarding the instructions or any aspect of the filter's maintenance.
How often should I service my K&N cabin air filter?

What products should I use to clean my filter?

Can I use hot water to rinse the filter?

Does the filter need to be completely dry before refreshing?

•1455 Citrus St. P.O. Box 1329, Riverside, C.A. USA 92502 • Tech Service 800-858-3333 • Fax 951-826-4001

•Email: tech@knlters.com• Web: knlters.com

18685B

5/2/17

K&N® CABIN AIR FILTER

CLEANING INSTRUCTIONS

When your cabin air lter(s) get dirty, the lter can be cleaned and reused. K&N® recommends

servicing your K&N® cabin air lter every 12 months or 12,000 miles. Best of all, the lter

comes with a 10 year/Million mile limited warranty. Servicing your K&N® cabin air lter is

simple: just follow the following 6 steps.

1.REMOVE FILTER: Remove the K&N® cabin air lter

from the cabin air lter housing and or cabin air lter tray.

Handling with care, remove loose dirt and debris from the

lter by tapping it with your hand or against a hard surface.

2. APPLY CLEANER: Spray a generous amount of K&N’s

specially formulated cabin air lter cleaner P/N 99-0650

onto both sides of the lter, with a majority of it applied to

the dirty side. Allow the cleaner to soak in for 10 minutes.

Do not allow the cleaner to dry on the cabin air lter.

5. REFRESHING: Apply K&N® cabin air lter Refresher™

P/N 99-0660 onto the cabin air lter element. Apply liberally,

so that the entire area of the cabin air lter media is treated.

3. RINSE FILTER: Rinse o the lter element with cool or

warm (not hot) water from the clean side out in order to

ush the dirt out of the lter. It may be necessary to use

your ngers on the hose, to apply light water pressure.

Repeat steps 2 and 3, until the water owing through the

media is completely clear of any dirt and debris.

4. DRY: After rinsing, gently shake o excess water. Allow

lter to dry naturally for 20-30 minutes. The lter does not

need to be completely dry and can be slightly damp before

moving to the next step.

6. RE-INSTALL: Re-install the cabin air lter into the lter

housing or tray. Follow original installation instructions that

were provided with your K&N® cabin air lter.

Use only K&N® cabin air lter RefresherTM kit, and not K&N® engine air lter Recharger® kit. The above process

is the only approved procedure for servicing your K&N® cabin air lter. Please visit knlters.com for a complete

listing of other K&N® products for your vehicle, such as oil lters, air lters, and intake kits.