WPI EVOM Quick start guide

Brand
WPI
Model
EVOM
Category
Measuring, testing & control
Type
Quick start guide
Main Display
Touch to short electrodes
Preview the plate by its
layout
File name, defined in the
storage options menu
Current cell in plate Battery indicator
Range (V, mV, Ω, KΩ)
Press to record and index
to the next well. Press and
hold to open the storage
options menu
Making Resistance Measurements
1. Power on the
EVOM™ Manual
using the power switch on the rear panel.
2. Ifalenameotherthanthedefault(plate1)isrequired,choosewhetheryouwillusea
prexandauto-indexingorauniquelename:
• Pressandholdthe
Store
buttononthemainscreenfor2secondsorpress
Store
Screen
on the
Setting
screentocongureyourstoreddatales.
• Touseaprexandauto-indexing,activatethe
Auto Index
radiobutton.Then,press
Store Prex
toenteralename.Or,touseauniquelename,deactivatethe
Auto
Index
radiobutton.Then,select
File Name
toenteranewname.
Press
Clear
.
• Usetheonscreenkeypadtoenteranewname.
• Press
Enter
.
NOTE
:Autoindexingchangesthenametoanumericsequenceformattedwiththename,
aprexandasequentialnumber(name_prexN).
3. Press
Setup
to access the
Setup
menu.
•
Select Plate
–Choose the plate size.
•
Select Mode Units
–ChooseOHMSorKOHMSformakingresistance
measurements.Selecttheresistancerange(autoor10,000ohms).
•
Ca
librate–PressCalibratetocalibratetheelectrode.(Thisusesa10KΩanda50K
Ω0.1%resistor).
•
Blank Handling
–Tosubtractablankwell(includingtheuidandelectrode
resistances),placetheelectrodeinablankwellandpress
Reading
. Press the
Blank Enable
radiobuttontosubtracttheblankvalue.
• Press
Return
tonavigatebacktothemainmenu.
4. InsertaUSBdriveintotheUSBportonthesideoftheEVOM™ Manualandbegin
measuringbypressingthefootswitchortouchingtheStore button on the screen. Tap
the Next Wellareaontherightsideofthescreentoadvancetothenextwell.Repeatthe
samplingprocess.
5. Oncethelastwellhasbeenrecorded,thelestoringselectionnoticationappears.
6. Press Store.AsystemmessagewillreportiftheUSBthumbdriveisusable,oritwilldisplay
anerror.IftheUSBthumbdriveisnotpluggedinoritisnotrecognized,awarningmessage
will appear. Press Cancelandtryanotherdrive.TheStorefunctioncannotbeusedonan
unrecognizeddrive.EVOM™ Manualshouldrespondwith“Filesaved”within15seconds.If
“Savingle...”isstillseenafter20seconds,presstheReturnkeyanduseanotherUSBdrive.
Oncealehasbeensaved,opentheleonacomputertoverifythecontents.
NOTE
:Thelesavingroutinecantakeupto15secondstocomplete.
7.
RemovetheUSBthumbdrivetotransferthedataletoyourcomputerasaCSVle(Excel).
WORLD
PRECISION
INSTRUMENTS
04/26/2022
www.wpiinc.com/evommanual
EVOM™ Manual TEER Measurement Meter
Quick Start Guide
Making Voltage Measurements
1. Power on the
EVOM™ Manual
using the power switch on the rear panel.
2. Ifalenameotherthanthedefault(plate1)isrequired:
• Pressandholdthe
Store
buttononthemainscreenfor2secondsorpress
Store
Screen
on the
Setting
screentocongureyourstoreddatales.
• Touseaprexandauto-indexing,activatethe
Auto Index
radiobutton.Then,press
Store Prex
toenteralename.Or,touseauniquelename,deactivatethe
Auto
Index
radiobutton.Then,select
File Name
toenteranewname.
• Press
Clear
.
• Usetheonscreenkeypadtoenteranewname.
• Press
Enter
.
NOTE
:Autoindexingchangesthenametoanumericsequenceformattedwiththename,
aprexandasequentialnumber(name_prexN).
3. Press
Setup
to access the
Setup
menu.
•
Select Plate
–Choose the plate size.
•
Select Mode Units
–Choosevoltsormillivolts(thenormalmodeismillivolts).
•
Electrode Equilibration
–Zerotheelectrodes’galvanicchargeinsaline.
• Press the
Probe Null
button. Push the
NULL
button.Waitforthesecondmessage
stating”Solutionvalue0.0”beforereturning.Thisactionremovesanyvoltageosets
ontheelectrodes.Thenactivatethe
Enable/Disable
radiobuttontoosetthe
electrodepotential.
4. InsertaUSBdriveintotheUSBportonthesideoftheEVOM™ Manualandbegin
measuringbypressingthefootswitchortouchingtheStore button on the screen. Tap
the Next Wellareaontherightsideofthescreentoadvancetothenextwell.Repeatthe
samplingprocess.
5. Oncethelastwellhasbeenrecorded,thelestoringselectionnoticationappears.
6.
Press Store.AsystemmessagewillreportiftheUSBthumbdriveisusable,oritwilldisplay
anerror.IftheUSBthumbdriveisnotpluggedinoritisnotrecognized,awarningmessage
will appear. Press Cancelandtryanotherdrive.TheStorefunctioncannotbeusedonan
unrecognizeddrive.EVOM™ Manualshouldrespondwith“Filesaved”within15seconds.If
“Savingle...”isstillseenafter20seconds,presstheReturnkeyanduseanotherUSBdrive.
Oncealehasbeensaved,opentheleonacomputertoverifythecontents.
NOTE
:Thelesavingroutinecantakeupto15secondstocomplete.
7. RemovetheUSBthumbdrivetotransferthedataletoyourcomputerasaCSVle(Excel).
(ABOVE) Back panel showing
the foot switch connection
on the far left and the power
switch on the far right.
(Right) Side view showing the USB
port and the electrode port.
WORLD PRECISION INSTRUMENTS
USA: 175SarasotaCenterBoulevard,SarasotaFL34240-9258USA
Tel: (941)371-1003•Fax: (941)377-5428•E-mail: [email protected]•Internet: www.wpiinc.com
UK: 1HuntingGate,Hitchin,HertfordshireSG40TJEngland•Tel:44(0)1462424700•E-mail:[email protected]
Germany: Pngstweide16,D-61169Friedberg(Hessen)•Tel:+49(0)603167708-0•Fax:+49(0)603167708-80•E-mail:[email protected]
China & Hong Kong:Rm27A,No8DonfangRd.,PudongNewDistrict,ShanghaiPRC•+8668885517•4006885517•[email protected]
  • Page 1 1

WPI EVOM Quick start guide

Brand
WPI
Model
EVOM
Category
Measuring, testing & control
Type
Quick start guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers