ALS RAL501R User manual

RAL501R
Brand
ALS
Model
RAL501R
Type
User manual

ALS RAL501R is a powerful and versatile work light designed to provide bright illumination in various settings. With its high-efficiency COB LED, it delivers up to 500 lumens of brightness, making it ideal for tasks that require good visibility. The light features three adjustable brightness levels - low, medium, and high - to suit different lighting needs. It also has a 90-degree rotating head for multi-angle illumination, allowing you to direct the light exactly where you need it.

ALS RAL501R is a powerful and versatile work light designed to provide bright illumination in various settings. With its high-efficiency COB LED, it delivers up to 500 lumens of brightness, making it ideal for tasks that require good visibility. The light features three adjustable brightness levels - low, medium, and high - to suit different lighting needs. It also has a 90-degree rotating head for multi-angle illumination, allowing you to direct the light exactly where you need it.

WALLI SERIES
RAL501R/RAL1K1R
FEATURES
SPECIFICATIONS
EN
MANUAL
• High efficiency COB LED provides lights with up to 500/1000 lumens respectively
• Illuminance - much greater than traditional underhood lights
• Light angle - more focused than traditional floodlights, protecting user eyes
• Strong magnets for handsfree use
• Lamp can be 90° rotated for multi-angle illumination
• Glow-in-the-dark fluorescent reflector makes lamp easy to locate in the dark
• Flush mounted hook at back can be rotated for hanging
• IP54 dust and water resistant, drop impact resistant
• HBS (human body sensor) - can be turned on to conserve power when user is away from lamp for an extended
period of time (only for RAL501R & RAL1K1R)
OFF
HBS function
PRESS
PRESS PRESS
Low Medium
PRESS
High
PRESS
• Before use, please connect light with cable and charger/adaptor/power bank/computer with
5V output, until the indicator turns to green (fully charged)
• To prolong the life of battery, please charge the light every three months
• Press the button to switch the modes
MODEL
50 lm
Light source
Luminous flux
18h
Operating time
Charging time
3.7V / 2200 mAh Li-ion
Battery
Temperature
IP54 / IK07
Protection class
Dimensions
Weight
RAL501R
MediumLow
250 lm
3.6h
High
500 lm
COB LED
1.8h
2.5-3h
0°C to 40°C
92x56x48 mm
260g
100 lm
18h
3.7V / 4400 mAh Li-ion
IP54 / IK07
RAL1K1R
MediumLow
500 lm
3.6h
High
1000 lm
COB LED
1.8h
3.5-4h
0°C to 40°C
152x60x48 mm
458g
PRESS
Only for RAL501R & RAL1K1R
• Avoid looking directly into the beam of light, as this will result in dazzling
• Do not use the lamp near a naked flame
• Before using the lamp for the first time, the battery must be fully charged
• The red charging indicator lights up during charging
• The green charging indicator lights up when charging is completed
• Recharge frequently
• Always replace the battery with an original ALS battery
• Do not leave the battery without charge for an extended period
- Deep discharge risks damaging the battery
•The light source of this lamp is not replaceable; when the light source reaches its end of life
the whole lamp shall be replaced
Discarded electrical products must not be disposed of together with household waste. Please
use recycling facilities. Ask your local authority or retailer for advice on recycling.
- The battery must be removed from the device before it is broken up
- The device must be disconnected from the mains when the battery is removed
- Please dispose of the battery safely
WARNING / CHARGING INSTRUCTION / BATTERY TIPS
CAUTION:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference. (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
V2/02.2022/WXF
Official website Patent information
AEC LIGHTING SOLUTIONS CO., LTD
2548 Bao'an Highway, Jiading District, Shanghai 201801, China
上海智汇电器有限公司
上海市嘉定区宝安公路2548号
邮编：201801
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

ALS RAL501R User manual

RAL501R
Brand
ALS
Model
RAL501R
Type
User manual

ALS RAL501R is a powerful and versatile work light designed to provide bright illumination in various settings. With its high-efficiency COB LED, it delivers up to 500 lumens of brightness, making it ideal for tasks that require good visibility. The light features three adjustable brightness levels - low, medium, and high - to suit different lighting needs. It also has a 90-degree rotating head for multi-angle illumination, allowing you to direct the light exactly where you need it.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents