Pyle PLRSTND10 Owner's manual

DIRECTIONS:

1. Attach the supports to the legs.

2. Assemble the cross bar on the leg and upright supports.

3. Tighten all the screws

4. Stick the rubber feet on the legs. There are two for each leg;

they go on the front and back of each leg

5. Then you can mount your equipment on this rack stand

with the screws and washers supplied. You can either place

it on a table or the ground

19” RACK STAND

QUICK USER GUIDE

MODEL: PLRNSTND10

Thank you for choosing this 19” rack stand.

IN THE BOX:

(2) Uprights supports

(2) Leg tubes

(2) Cross bars

(8) Screws

(may already be in tubes, in which case, you’ll need to remove them for assembly)

(4) Transparent rubber feet

* Additional screws and washers needed for mounting

Upright

Support

Leg

Tube

Cross

Bar

SPECIFICATIONS:

Construction Material: Steel

Maximum Weight Load Capacity: 110 lbs.

Assembled Dimensions (L x W x H):

19.3’’ x 14.0’’ x 21.7’’