For a foot massage, place the
Hydro-Massage Pad on the floor
of your shower or bath. Step onto
the pad with both feet. If desired,
activate the massager by pressing
the on/off switch.
The Hydro-Massage Pad can also
be used for a back massage.
Position the pad against the curve
at the back of the tub. Sit down
with your back resting against the
pad. If desired, activate the mas-
sager by pressing the on/off
switch.
To dry the Hydro-Massage Pad,
insert the included hook through
the hole in the pad and hang the
pad up as shown. Make sure to
hang the pad from an object that
is capable of supporting the
weight of the pad.
Using the Hydro-Massage Pad
The Hydro-Massage Pad requires
four ÒCÓ batteries (not included). To
install batteries, remove the six
screws (1) and lift up the battery
cover (2). Press four ÒCÓ batteries
into the battery holder. Position the
batteries as indicated on the dia-
gram inside the holder. Reattach
the battery cover with the six
screws. Follow the same procedure
to replace the batteries.
Turning the Massager On and Off
Installing Batteries
Simply press the on/off switch to
activate the massager. Press the
switch again to shut it off.
Important Precautions
CAUTION: The Hydro-Massage Pad should not be used
for more than 20 minutes per session.
CAUTION: Before using the Hydro-Massage Pad, make
sure that the suction cups on the bottom of the pad are
properly sealed to the bath or shower floor.
1
1
2
On/off
switch