PJ-1614NXE PJ-2216NXE OPERATION MANUAL ERRATA
April 2002
PJ16E-A-00d 4 MUTOH INDUSTRIES LTD.
Page Item Description
p.4-49 Modify the following items
in “4.5.4 Head cleaning”
Headline
False: If the printed screen is smeared or misprinted, perform
cleaning of the print head surface and the nozzles (head
cleaning).
True: Clean the print head surface and the nozzles (head cleaning)
when:
Printing becomes smeared or misprinted
Waiting mode lasts over 1 hour with the power source supplied
Add
NOTE
If printing problems are not corrected by increasing purge
mode to "high", clean off the print head surface using a
poly-nit wiper soaked in jet wash fluid then perform head
cleaning again.
p.5-9
p.5-11
Modify ”5.2.3 Replacement
of the ink filter”
Refer to sheet 37
p.5-11 Add “5.2.4 Replacement
of the print head and
CR motor”
Refer to sheet 38 39
p.5-12
Modify the second term
of
CAUTION
in
“5.3 Cleaning the printer”
CAUTION
Do not use the jet-wash fluid, thinner, Benzene,
alcohol, or other active agents except for the following
parts:
Inside the maintenance cover
Print head surface
Doing so may result a malfunction in the product.
p.5-13 Modify “(1) Cleaning
interval” in “5.3.2
Cleaning inside the
printer”
False: Clean once a month.
True: Clean once a week
.
p.5-18
p.5-20
Modify the following items
in “5.4 Long term
storage cleaning”
”(1) Cleaning interval”
False: When not using the unit for over 2 weeks…
True: When not using the unit for over a week…
”(2) Cleaning procedure” Refer to sheet 40 42
p.6-8
p.6-9
Add the descriptions to
“6.3.1 Status messages”
Refer to sheet 43
p.7-3 Modify “Outer diameter
dimension: Depth “ in
“7.2.2 PJ-2216NXE
Unit specifications”
False: 720mm (28.3in.)
True: 802mm (31.6in.)
Appendix
Modify “Onsite
Adjustment
Verification”
Refer to “Onsite Adjustment Verification”
