5019 301 20128
GB
Quick Reference Guide
Please read the Instructions Manual carefully before using your new washing machine
(We reserve the right to make technical modifications)
Whirlpool is a registered trademark of Whirlpool USA
Programme selector
To select a programme, turn the knob.
“ON/OFF” button
When you press this button, the washing machine is
switched on.
“ON/OFF” indication
The indicator lamp lights up when the washing
machine is on.
Temperature selector knob
Set the temperature selector knob to the desired
temperature.
Changing or interrupting the programme during the wash cycle
To change a programme when a cycle has already begun:
Switch off the appliance by pressing the “ON/OFF” button”.
Select the new programme.
Start the programme by pressing the “ON/OFF” button”
Options
When the combination of programme, additional options and
temperature is not possible, the indication lights switch off automatically.
Unsuitable combinations of options are deselected automatically.
Cancelling a programme before the end
Switch off the appliance by pressing the “ON/OFF” button”.
Set the programme selector to programme setting “Drain/Spin”.
Switch on the appliance by pressing the “ON/OFF” button”.
Intensive rinse button
More water and a longer time in rinse cycle is added.
The intensive rinse function is especially suitable for
areas with particularly soft water, for baby clothes
and to help people with allergies.
Rinse Hold
The laundry remains in the last rinse water without
progressing to the final spin cycle to avoid creasing
and prevent colours from changing.
This option is particularly recommended for the
programme “Synthetics” or “Delicates”.
This function is particularly useful if you want to postpone
spinning to a later time, or if you want to drain only.
Note:
The programme stops to “Rinse Hold” at the
time the “Rinse Hold” light in the programme flow
indication is on.
To terminate the “Rinse Hold” option:
Press the “Rinse Hold” button again; the programme
will terminate automatically with the final spin cycle
for the present wash programme.
No Spin
Especially for delicate garments to avoid wear and
tear caused by the spin.
Note:
In the “Cotton” and “Synthetics” programmes
the machine will perform a short spin at a low speed,
even if the spin cycle has been disabled, so as to
optimise rinsing operations.
Half load
Reduces water consumption above all during rinsing.
Suitable for lightly soiled laundry and small loads (max 2.5 kg).
Note:
Reduce the detergent quantity.
Power and water consumption data
Programme
Temperature
selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Programme Duration
approx.
(hours : minutes)*
Prewash cycle increases programme duration
by approx. 15 minutes. Consumption values
were measured in normalized conditions in
compliance with Standard IEC 60 456.
Consumption data in the home may vary with
respect to the values in the table in relation to
the water supply pressure and temperature,
the load and the type of wash.
* The remaining time display may differ from
the values given in the table since it depends
on the conditions of use in the home.
** To reduce the water temperature, some
cold water is added at the end of the main
wash cycle, before the pump drains the
water out.
Cotton
90 5.0 75** 1.80 2:39
Cotton
60 5.0 75 1.22 2:40
Cotton
40 5.0 75 0.50 2:19
Quickwash
— ——— —
Synthetics
60 2.5 54 0.78 1:02
Synthetics
40 2.5 54 0.42 0:43
Delicates
— ——— —
Wool
40 1.0 59 0.24 0:45
30120128GB.fm Page 4 Wednesday, June 14, 2006 5:53 PM
Black process 45.0° 150.0 LPI