LADEN WBE3411 A+W AQUA Program Chart

WBE3411 A+W AQUA
LADEN
Brand
LADEN
Model
WBE3411 A+W AQUA
Type
Program Chart

This manual is also suitable for

Refrigerator Compartment
1. Fan*
1a. on/off fan button
1b. cover of fan
2. Shelves / Shelf area *
3. Thermostat / light unit
4. Rating plate with commercial name
5. Fruits and vegetables crisper
6. Crisper divider *
7. Doors reversibility kit
8. Door trays
9. Bottle holder *
10. Water tank
11. Egg tray *
12. Door seals
Freezer Compartment
12. Door seals
13. Storage zones for frozen food items
(basket or flap)
13a. ECO GREEN basket for freezing fresh food or to
store frozen food (only in models provided with
ECO GREEN function)
14. Bottom basket for freezing fresh food or to store
frozen food
15. Ice tray*
Anti-bacterial protection:
- Antibacterial filter* in the fan (1)
- Antibacterial additives* in the material of Crisper (5)
- Door seals are made of material able to inhibit
bacterial growth (12)
* Available on selected models
Notes:
- All shelves and door trays are removable.
- The internal temperatures of the appliance may be
affected by the ambient temperature, frequency of
door opening, as well as location of the appliance.
Temperature setting should take into consideration
these factors.
- The appliance accessories are not dishwasher safe.
- After inserting food, ensure that the freezer
compartment door closes properly.
HOW TO INCREASE FREEZER STORAGE
CAPACITY
You can increase storage capacity in the freezer
compartment by:
- removing the baskets and the flap to allow the
storage of big products.
- placing the food products directly on the freezer
shelves.
- removing the lower basket, the shelf (additional
inside product) has to be placed in freezer
compartment. The space below the shelf is 2 stars
(< -12 °C) and it is for frozen foodstuffs with short
storage time.
- the bottom basket is specific compartment for
freezing large food. After inserting food, ensure that
the freezer compartment door closes properly.
HOW TO START THE APPLIANCE
After plugging the appliance to the mains, it starts the
operation automatically.
After starting the appliance, wait at least 4-6 hours
before placing food into the appliance.
Note:
- If food is placed in the refrigerator before the
appliance has cooled completely, it may deteriorate.
FAN
The Fan improves temperature distribution inside the
refrigerator compartment, allowing better preservation
of stored food.
By default, the fan is switched on.
It is advisable to keep the fan switched on when the
ambient air temperature is above 27 ÷ 28°C or if you
notice drops of water on the glass shelves or in sever
humidity conditions.
Please note that when the fan is switched on it will not
continuously work.
The fan will start/stop working depending on the
temperature and/or humidity level inside the fridge. It
is therefore absolutely normal if the fan does not move
even if the fan is switched on. The fan automatically
stops working when the fridge door is open.
Note: Do not obstruct the air intake area with food
items.
To guarantee the right performance at lower ambient
temperature (colder than 18°C) and to minimize
Energy Consumption, turn off the fan.
To turn off the fan press the button of fan (1a).
ANTIBACTERIAL FILTER
(available on selected models)
If the appliance has the Fan it can be equipped with
the antibacterial filter.
Remove it from the box placed in the crisper drawer
(5) and insert into the cover of fan (1b).
The replacement procedure is attached with the filter.
2
3
4
5
6
7
8
10
9
12
1a
1b
on - o
11
13
14
15
1
13a
PRODUCT SHEET
EN
GB FIDKCZBGDEFRNLPL SKRUROPTNOITHUGR UASEES
PRODUCT SHEET
EN
GB FIDKCZBGDEFRNLPL SKRUROPTNOITHUGR UASEES
ECO GREEN FUNCTION (available on selected
models)
This function gives best food preservation
performance with the smallest energy
consumption if there is lower amount of food
to be preserved in the appliance.
The best food preservation conditions when
ECO GREEN function is activated are in the
ECO GREEN compartments:
- 2 “eco green” areas in the fridge (indicated
by green stickers)
- 1 “eco green” basket in freezer
compartment
To select the function turn the ECO GREEN
symbol on the knob of the regulator.
FRIDGE/FREEZER
COMPARTMENT
CONTROLS
A. Thermostat knob
B. Light button
C. Thermostat setting indicator
D. Light bulb
The thermostat adjusts temperature in both
compartments.
Thermostat set to 1/MIN: low cooling intensity
Thermostat set between 1/MIN and 7/MAX : cooling
intensity can be adjusted according to the preferences.
Thermostat set to 7/MAX: maximum refrigeration
intensity.
For the best food conservation 3-5/ MED position is
recommended.
Thermostat set to
•
: cooling and lighting off.
Thermostat set to ECO GREEN : ECO function active.
REPLACING THE LIGHT BULB
Before replacing the bulb, remove the power plug from
the mains socket.
To remove the light bulb turn anticlockwise as shown
in figure.
Check the bulb. If necessary unscrew the broken bulb
and replace it with a traditional bulb (with the same
characteristics of the previous one) or a LED bulb of
the same type available only at our After-sales Service
Centers or authorized dealers.
FREEZING FRESH FOOD
Place the fresh food to be frozen into the bottom
basket.
Avoid direct contact with already frozen food.
DEFROSTING THE REFRIGERATOR
COMPARTMENT
Refrigerator compartment defrosting is completely
automatic.
Droplets of water on the rear wall inside the refrigerator
compartment indicate that the automatic defrost phase
is in progress. The defrost water is automatically run
into a drain hole and collected in a container, where it
evaporates.
DEFROSTING THE FREEZER
COMPARTMENT
The freezer should be defrosted
once or twice a year or when
excessive frost is present (3 mm
thickness).
The formation of frost is normal.
The amount and rate at which frost
accumulates depends on room conditions and how
often the door is open.
To defrost the unit, switch off the whole appliance and
remove all food products.
Leave the freezer door open to allow the frost to melt.
Pull out the defrost water drain and place a container
under the drain (see figure).
When the operation is completed, put back the defrost
water drain.
Clean the inside of the freezer. Rinse and dry
thoroughly. Switch on the appliance and store the food
inside.
CLEANING
Important: Before carrying out any cleaning or
maintenance operation, unplug the appliance or
disconnect it from the power supply.
Regularly clean the appliance using a cloth and a
solution of warm water, with some soft detergent
suitable for cleaning the inside of the refrigerator
compartment.
Do not use abrasive detergents or tools.
To ensure continuous and correct flow of defrost
water, regularly clean the inside of the draining hole on
the back of the refrigerator near the fruit and vegetable
drawer, using the tool provided.
UTILISATION AND MAINTENANCE OF THE WATER DISPENSER AND FILTER
Water dispenser
First use
The first time you use the water dispenser or after a long period left not used wash the tank and the filter with
water.
The water dispenser provides fresh, filtered water, without the need of opening the refrigerator door. This will
reduce the number of times the door is opened, thus also reducing energy consumption of the product.
Fitting and replacing the active carbon filter
The water filter should be removed from the foil bag (found in the crisper drawer (item 5). Follow the instructions
provided with the filter.
Important: If the filter is left dry for an extended period of time, its performance may be reduced. Immerse the
filter in water for a few seconds to reinstate optimum performance.
To ll the tank, rotate the cap in the
direction of the arrow
Tank
Fig.1
Water tank (g. 1)
The water tank is made of antibacterial material. This prevents and reduces
the proliferation of bacteria. An internal container, with an active carbon
ltered ensures water ltration.
To ll the tank: rotate the water inlet towards you and ll with water, using a
jug or other suitable container. Once the tank is full, close the water inlet by
moving it back to its original position.
Always use drinking water only: any other liquid may impair product
performance.
Stop
Activation
device
Water
drip
tray
Fig.2
Obtaining ltered water (g. 2)
After lling the tank, the water may not be immediately available. This is
because the ltering process may require a few minutes (depending on the
amount of water in the tank).
To dispense water: with the refrigerator door closed, press the water
dispenser tab with the glass. If for safety reason water delivery must be
prevented, simply press the stop at the back of the tab. To release water
delivery, move the stop back to its original position. It is recommended to
drink the supplied water from the dispenser in 6 hours.
Fig.3
Cleaning the water tank (g. 3-4-5-6-7-8-9)
Periodically clean the water tank with running water. Twice a year it is
recommended to keep healthy the unit using specic products based
on diluted chlorine that not modify the material properties and rinse with
current water.
To clean the tank, proceed as follows:
- (g. 3) release and remove the upper door tray
Fig.4
- (g. 4) release and remove the water tank by lifting it and pulling towards
you. Place the tank on a at surface, remove and wash the top cover.
Note: the tank must be retted in its position as soon as possible, to
prevent the refrigerator from overheating.
GB FIDKCZBGDEFRNLPL SKRUROPTNOITHUGR UASEES
PRODUCT SHEET
EN
Fig.5
- (g. 5a -5b) remove the internal container and the lter, and wash them
separately.
When washing the lter, only use clean water (no detergent or sharp
tools). To clean the disk lter, rst remove it from the container.
Fig.6 Fig.7
- (g. 6) for a more thorough cleaning, remove the valve cap (the tting
connecting the tank to the refrigerator) by rotating it anticlockwise. Clean
the cap. Important: do not pull on the valve body (g. 7).
Fig.8
- (g. 8) replace the valve cap by rotating clockwise.
Fig.9
- (g. 9) t the tank back in place by placing it between the lateral guides
of the door and pushing it in position, ensuring that the valve is back in its
original seat. Check that the there are no gaps between the rubber seal of
the tank and the door.
Water Filter Duration
To ensure optimum performance you should change the water filter according with the following table:
Water
consumption
(average)
Filter duration
3,0 l/day 4 months
4,5 l/day 3 months
6,0 l/day 2 months
Filter replacement is not covered by product warranty. To order more water filter cartridges, please contact your
after-sales service.
5019 320 00110 Printed in Poland 11/13
GB FIDKCZBGDEFRNLPL SKRUROPTNOITHUGR UASEES
PRODUCT SHEET
EN
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

LADEN WBE3411 A+W AQUA Program Chart

WBE3411 A+W AQUA
LADEN
Brand
LADEN
Model
WBE3411 A+W AQUA
Type
Program Chart
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents