Adax VP11 Series Installation guide

Brand: Adax

Model: VP11 Series

Type: Installation guide

Adax VP11 Series: Experience reliable heating solutions with our advanced electric panel heater. Equipped with a precise thermostat for customized temperature control, this heater offers three operation modes – off, on, and automatic – for energy-efficient heating. Program your desired heating schedule using the timer with 15-minute intervals to match your daily routine. The overheating cut-out ensures safe operation, while the sleek design complements any room décor.

Electric installation in bathrooms

must be carried out by an authorised electrician.

Installation instructions

220-240 Volt ~ , IP 20, Class II

print # 62232

081112

= Neutral = Blue

= Live = Brown

Permanent electric installation

must be carried out by an authorised electrician

200

300

600

370

430

540

660

730

950

1175

500

750

1000

1250

1500

2000

2500

Watt

VP11 T/tim

Oil fumes,

max. 5 min.

The overheating

cut-out resets

automatically

Clean every month during period of use

If room temperature

and thermostat

setting deviate:

230 V ~

IP20

1 3

Calibrate by

holding the

scale while

turning the

knob

4 5 6

Instructions for use

220-240 Volt ~ , IP 20, Class II

The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,

or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the

appliance by a person responsible for their safety.

Children should be supervised to ensure they do not play with the appliance.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent

or similarly qualified persons in order to avoid a hazard.

Please note that

this symbol means

“Do not cover”.

Actuators,

position ON

Actuators,

position OFF

Switch

0 = Off

The heater is switched off all

the time

I = On

The heater is switched on all

the time and the temperature

is regulated by the thermostat.

= Automatic

The heater is switched on and

off by the timer. When it is

switched on, the temperature

is regulated by the thermostat.

When the heater is switched

off, no heat is provided and

the temperature depends on

conditions in the room and

the outside temperature which

may sink to below zero; i.e.

there is no safeguard against

frost.

Programming (automatic)

The outer ring on the timer consists of switch actuators

that can be pushed in and out. Each actuator represents

a period of 15 minutes. When an actuator is pressed

away from the centre of the circle, the heater will be

switched on and will work according to the thermostat

setting for this 15 minute period.

A short warm-up period is necessary from the time

when the heater is switched on until the desired room

temperature is reached, depending on the size of the

room, insulation, etc.

Experience will show how long a warm-up period is

required. A typical example may be having the actuators

pushed to the on position from 6.00 to 8.30 and from

16.00 to 23.00, as illustrated.

To set the correct time

Set the timer to the correct time by turning the outer

ring of actuators so that the correct hour is adjacent to

the arrow (the illustration shows the timer set to 21.00,

i.e. 9 p.m.)

print # 62232

081112

VP11 T/tim

Adax VP11 Series Installation guide

Adax VP11 Series Installation guide

Adax VP11 Series Installation guide

Related papers

Other documents