INTRODUCTION
These instructions are intended to be a guide for general opera-
tion of this device. For complete instructions on capping con-
crete specimens with sulfur mortar, please refer to ASTM C 617
or AASHTO T 231.
UNPACKING & SETUP
Carefully inspect melting pot for shipping related damages. Re-
port any damage to the shipping company as soon as possible.
Connect unit to a properly grounded power supply with
the correct voltage and amperage requirements. (Electrical
requirements are listed on the specication tag of each unit.)
WARNING!
• Use this device only in a properly ventilated area.
• NEVER leave a melting pot unattended during
operation. Unplug the pot when not in use.
• Wear protective eye wear and gloves when using the
melting pot. DO NOT wear shorts or short-sleeve shirts.
OPERATING INSTRUCTIONS
For All Units:
• Consult supplier of material to be melted for the correct
melting temperature. NEVER set controls above that
temperature.
HM-205
• Keep cover in place. This speeds melt time, reduces o-gassing
and prevents contamination of the material.
For Operation with a Timer:
• Select a timer that meets or exceeds electrical requirements
of melting pot.
• Connect timer to a properly grounded power supply meeting
the specied requirements.
• Plug melting pot power cord into timer receptacle.
• Set timer to turn on melting pot two hours before arrival and
to turn o at the end of the work day.
ASTM C 617; AASHTO T 231
Melting Pot
HM-200, HM-201, HM-202, HM-204, HM-205
& HM-206
OPERATING MANUAL
Rev: 01/2019
PHONE: 800-444-1508 P.O. Box 200, Lewis Center, Ohio 43035-0200
740-548-7298 E-mail: customerservice@gilsonco.com Product Web Page: www.globalgilson.com
FAX: 800-255-5314
740-548-5314
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Gilson SGA-5RT Operating instructions
-
Gilson Rice Test Shaker User manual
-
-
-
-
Gilson Load Frame User manual
-
-
-
-
