Dakota Digital VHX-67C-IMP Mounting Manual

Manual # 650481A

VHX-67C-IMP

Dakota Digital VHX Instrument Installation

For 1967 Chevrolet Impala and Caprice

Your new VHX-67C-IMP kit includes:

Installation

Installation Manuals

Control Box

(2) 36” CAT5 Cable’s

Universal Sender Pack

VHX Display

1. First, remove the stock gauge cluster from the dash. Retain the factory hardware for reassembly.

Clock Harness

Switch Assembly

Manual # 650481A

WARNING: This product can expose you to chemicals including lead, which is known to the State of

California to cause cancer and birth defects or other reproductive harm. For more information go to

www.P65Warnings.ca.gov

3. Mount the VHX system to the stock bezel using the factory screws from the previous step.

2. Remove the stock gauges from the

bezel and retain the hardware for

reassembly. You can also remove the

factory clear lens on the front of the

bezel or it can be left in place if desired.

4. Attach the provided CAT5 cables and

the clock harness to the back of the

VHX system and carefully route the

open ends to the control box mounting

location.

5. Re-install the gauge bezel using the factory hardware and refer to manual 650314 and 650462

for wiring instructions to complete the VHX installation.