Air Live POE-280HD User manual

Table of Contents

AirLive POE-280HD User’s Manual

0

Use

r

’s Manual

H.264 1.3 MegaPixel IR Night

Vision Dome Camera

POE-280HD

Copyright and Disclaimer

AirLive POE-280HD User’s Manual

i

Copyright & Disclaimer

No part of this publication may be reproduced in any form or by any means, whether

electronic, mechanical, photocopying, or recording without the written consent of OvisLink

Corp.

OvisLink Corp. has made the best effort to ensure the accuracy of the information in this

user’s guide. However, we are not liable for the inaccuracies or errors in this guide.

Please use with caution. All information is subject to change without notice

All Trademarks are properties of their respective holders.

Copyright and Disclaimer

AirLive POE-280HD User’s Manual

ii

FCC Statement

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

FCC Caution

Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate this equipment. This device complies

with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation. For

product available in the USA/Canada market, only channel 1~11 can be operated.

Selection of other channels is not possible.

This device and its antenna(s) must not be co-located or operation in conjunction with any

other antenna or transmitter.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance

20cm between the radiator & your body.

Table of Contents

AirLive POE-280HD User’s Manual

iii

Table of Contents

1. Overview...................................................................................................1

1.1 Introduction ..........................................................................................1

1.2 Features...............................................................................................1

1.3 Product Specification ...........................................................................2

1.4 System Requirement ...........................................................................3

2. Package Contents and Installation ........................................................4

2.1 Hardware Overview .............................................................................4

2.2 Hardware Installation ...........................................................................6

2.3 Connect to IP Camera .........................................................................9

3. Using IP Camera via Web Browser ......................................................11

3.1 Windows Web Browser......................................................................11

3.2 Mac Web Browser..............................................................................12

4. Operating IP Camera via Mobile Phone ...............................................15

4.1 Mobile Phone Viewing .......................................................................15

4.2 Using IP Camera via iPhone..............................................................16

5. Configuration of Main Menu .................................................................17

5.1 Live View............................................................................................18

5.2 Setting................................................................................................19

5.3 Client Setting .....................................................................................20

5.4 Image Setup ......................................................................................21

6. Setting-Basic..........................................................................................22

6.1 System...............................................................................................22

6.2 Camera ..............................................................................................27

6.3 Network..............................................................................................39

6.4 Security..............................................................................................51

7. Setting-Advanced ..................................................................................55

7.1 FTP Client ..........................................................................................55

7.2 SMTP.................................................................................................60

Table of Contents

AirLive POE-280HD User’s Manual

iv

7.3 Network Storage ................................................................................66

7.4 Memory Card .....................................................................................71

7.5 HTTP Event .......................................................................................75

7.6 Alarm output.......................................................................................78

7.7 Schedule............................................................................................79

7.8 Alarm Input.........................................................................................81

7.9 Alarm Buffer .......................................................................................82

7.10 Motion Detection..............................................................................82

7.11 System Log ......................................................................................84

8. Appendix ................................................................................................85

A. Frame-rate and Bitrate Table............................................................85

B. Storage Requirement Table ..............................................................90

1. Overview

AirLive POE-280HD User’s Manual 1

1

1. Overview

This user’s guide explains how to operate this camera from a computer. User should read

this manual completely and carefully before you operate the device.

1.1 Introduction

The AirLive POE-280HD is a high-end 1.3 -megapixel network camera designed for

professional indoor surveillance and security applications. Megapixel (MP) IP cameras are

now available that offer a huge jump in image quality compared to conventional

surveillance cameras. This new model complements an architecture and software that is

based on variations for professional indoor surveillance and security applications. The

possibility to view video from AirLive IP Cameras over the Internet is only one of the

benefits. AirLive POE-280HD is designed to offer high-performance and is equipped with

PoE port, ensuring to power IP camera and provide network activity via one RJ45 network

cable. This provides an easier installation and lower cable costs and allows placement of

Airlive POE cameras in locations with power limitation. The built-in IR LED and ICR make

POE-280HD provide a clear and smooth video image even in the night time or in a low

illumination environment. For applications such as hallways or stairwell, the POE-280HD is

an ideal IP camera for these locations.

1.2 Features

This manual will illuminate the steps of how to setup and operation this IP camera, so you’ll

also soon be enjoying the benefits of these product features:

 UPnP for fast and easy installation

 Support 18pcs high illumination LED

 1.3 megapixel progressive scan CMOS

 Multiple H.264, Motion JPEG and MPEG-4 video streams

 Mobile Phone Live Viewing

 64 channel surveillance software

 IR Night Vision Dome Camera suits various of application

1. Overview

AirLive POE-280HD User’s Manual 2

1.3 Product Specification

Models

AirLive POE-280HD

Image sensor

1/4” Progressive scan CMOS 1.3 Megapixel sensor

Lens

F1.5, 4.0mm Megapixel board lens

Digital Zoom

10x digital

Min Illumination

0 Lux with Night-vision LEDs on

IR working distance

15 M

Video Compression

H.264 / MPEG-4 / Motion JPEG

Resolutions

UP to 1280 x 1024

Frame rate

Motion JPEG: Up to 15 fps at 1280x1024

Up to 30 fps at 640x480

MPEG-4: Up to 15 fps at 1280x1024

Up to 30 fps at 640x480

H.264: Up to 15 fps at 1280x1024

Up to 30 fps at 640x480

Video streaming

Simultaneous Motion JPEG, MPEG-4, H.264 and

3GPP (4 streaming)

Wireless

None

Alarm and event

management

Input: alarm buffer, motion detection

Output: network storage, FTP, SMTP, HTTP event

Pre-and post alarm buffer

Casing

PC+ABS casing

Power

12V DC, 1A, Max 5W

Operating

conditions

Operation: Temp: 0 ~ 50 (32 ~ 122 )

Humidity: 20% ~ 85% non-condensing

Supported

protocols

Bonjour, TCP/IP, DHCP, PPPoE, ARP, ICMP, FTP,

SMTP, DNS, NTP, UPnP, RTSP, RTP, HTTP, TCP,

UDP, 3GPP/ISMA RTSP

Dimension

HxWxD:145x145x100 mm

Approvals

CE, FCC, RoHS

1. Overview

AirLive POE-280HD User’s Manual 3

1.4 System Requirement

For normal operation and viewing of the network camera, it’s recommended that your

system meet these minimum requirements for proper operation:

Item Requirements

CPU Pentium 4 2.8GHz (or equivalent AMD)

Graphic Card 256 MB RAM graphic cards(or equivalent on-board graphic

cards)

RAM 1G

Operating

System

Windows 2000, Windows 2003, Windows XP, Windows Vista,

Windows 7, and Mac OS X Leopard

Web Browser Internet Explore 6 or later

Note: Please keep updating the latest Windows software and service package. (Ex: Net

Framework, Windows Media Player, Enhance ActiveX Security)

2. Package Contents and Installation

AirLive POE-280HD User’s Manual 4

2

2. Package Contents

and Installation

User can find the following items in the package as below:

1. POE-280HD is the main element of the product.

2. Bundle CD include Setup Wizard II, Quick Start Guide, User Manual and other tools

3. Power Adapter dedicates 12V DC electric power output to Network Camera.

4. Quick Start Guide provides important information and instructions for installing this

device.

5. Accessory Package

2.1 Hardware Overview

Inside View

2. Package Contents and Installation

AirLive POE-280HD User’s Manual 5

LED Indicator

Steady orange means SD card ready SD Card Orange

Flashes orange while accessing SD card.

Red Steady red for booting up process; Steady red 30

Seconds when WPS configure failed.

Blue Steady blue for booting up competition.

Purple Flash purple during firmware upgrading.

Power

Unlit When you press reset button.

Back Side View

LED Indicator

Green Steady green for Network link. Network

Orange Flash orange while Network activity.

Reboot Press the Reset Button to reboot the camera. Reset

Reset to

Factory Default

Hold the Reset Button for 10 seconds to restore the

camera to default

2. Package Contents and Installation

AirLive POE-280HD User’s Manual 6

2.2 Hardware Installation

Follow these steps to install the POE-280HD on your Ethernet:

A. Wall mounting and Ceiling mounting

1. Attach the alignment sticker to the wall/ceiling and drill two pilot holes into it.

2. Hammer the supplied plastic anchors into the holes.

3. Align the three holes on the base of camera with the three plastic anchors on the wall

and ceiling, insert the supplied screws to the corresponding hole and screw them.

B. Connect Cables

1. Power over Ethernet (PoE)

Using a standard RJ-45 network cable, connect the IP Camera to a PoE-enabled Hub /

Switch / Router

2. Package Contents and Installation

AirLive POE-280HD User’s Manual 7

2. Without Power over Ethernet (PoE) connection

Connect the power adaptor to the IP Camera. Using a standard RJ-45 network cable,

connect the IP Camera to a normal Hub / Switch / Router.

2. Package Contents and Installation

AirLive POE-280HD User’s Manual 8

C. Adjust the view angle- 3 axis Mechanism Design

1. Turn the lens module right and left to your desired pan position.

2. Turn the lens module up and down to your desire tile position.

3. Turn the lens module to adjust the image orientation to satisfied angle.

D. Completion

1. Clean the dome bubble to remove the dust and finger print.

2. Rotate the black shield on the dome bubble to match the camera’s position.

3. Fasten the dome cover to the base clockwise and make secure two parts reaching the

final position by checking two small dots on the side of housing

4. Slightly adjust dome bubble to final position if needed and double check the camera is

properly focused.

5. The installation is complete now.

2. Package Contents and Installation

AirLive POE-280HD User’s Manual 9

2.3 Connect to IP Camera

A. Insert the bundle CD into your PC/Laptop

B. Auto Run Screen then shows up, click “Install Driver & Utility Æ IP Search Tool” to

install the configuration tool software

2. Package Contents and Installation

AirLive POE-280HD User’s Manual 10

C. After complete installation, run the configuration tool software

D. The Software scans the network and finds the IP Camera, then list in the dialog box.

E. If the Camera’s IP address is in the same IP segment as your LAN, select the founded

IP Camera and double click on the item, then the default browser will show up and

connect to the IP camera’s Web automatically.

3. Using IP Camera via Web Browser

AirLive POE-280HD User’s Manual 11

3

3. Using IP Camera via

Web Browser

3.1 Windows Web Browser

A. Open your web browser, and enter the IP address or host name of the IP camera in the

Location / Address field of your browser.

Note: If you only want to view the video without accessing Setting screen, enter

“http://<IP>/index2.htm” as your web URL.

B. Use the default account “admin” and default password “airlive”.

Note: The default user name “admin” and the password “airlive” are set at the factory

for the administrator. You can change them in the Account Menu. (Please check

“Setting → Basic → Security → Account”)

C. The monitor image will be displayed in your browser. In the far left side of main

configuration are Setting, Client Setting, and Image Setup.

3. Using IP Camera via Web Browser

AirLive POE-280HD User’s Manual 12

3.2 Mac Web Browser

A. Click the Safari icon, and enter the IP address of the IP camera in the Location /

Address field of your browser.

3. Using IP Camera via Web Browser

AirLive POE-280HD User’s Manual 13

Note: If you only want to view the video without Setting screen “http://<IP>/index2.htm”

as your web URL.

B. Enter the default account “admin” and default password “airlive”.

Note: The default user name “admin” and the password “airlive” are set at the factory

for the administrator. You can change them in the Account Menu (Please check

“Setting → Basic → Security → Account”)

3. Using IP Camera via Web Browser

AirLive POE-280HD User’s Manual 14

C. The monitor image will be displayed in your browser. In the far left side of main

configuration are Setting, Client Setting, and Image Setup.

4. Operating IP Camera via Mobile Phone

AirLive POE-280HD User’s Manual 15

4.1 Mobile Phone Viewing

4

4. Operating IP Camera

via Mobile Phone

 3G Mobile Phone Streaming Viewing

For 3G mobile phone viewing, type “rtsp://<IP>:<PORT>/video.3gp ” into your 3G

Streaming Link. <IP> is the Public IP address of your IP camera; <PORT> is the RTSP

port of your IP camera (Default value is 554.) Example:

rtsp://100.10.10.1:554/video.3gp

Note: You can also use RTSP clients (RealPlayer, VLC, QuickTime Player…etc.) to

view RTSP streaming, just type in “rtsp://<IP>:<PORT>/video.3gp” as the Player URL

 2.5G Mobile Phone WAP Viewing

For 2.5G mobile phone viewing, type “http://<IP>/mobile.wml” into your 2.5G WAP

Browser. <IP> is the Public IP address of your IP camera.



2.5G Mobile Phone Browser Viewing

For 2.5G mobile phone viewing, type “http://<IP>/mobile.wml ” into your 2.5G Web

Browser. <IP> is the Public IP address of your IP camera.

Page is loading ...

Air Live POE-280HD User manual

Air Live POE-280HD User manual

Related papers

Other documents