Page is loading ...
Table of Contents
AirLive POE-280HD User’s Manual
0
Use
r
’s Manual
H.264 1.3 MegaPixel IR Night
Vision Dome Camera
POE-280HD
Copyright and Disclaimer
AirLive POE-280HD User’s Manual
i
Copyright & Disclaimer
No part of this publication may be reproduced in any form or by any means, whether
electronic, mechanical, photocopying, or recording without the written consent of OvisLink
Corp.
OvisLink Corp. has made the best effort to ensure the accuracy of the information in this
user’s guide. However, we are not liable for the inaccuracies or errors in this guide.
Please use with caution. All information is subject to change without notice
All Trademarks are properties of their respective holders.
Copyright and Disclaimer
AirLive POE-280HD User’s Manual
ii
FCC Statement
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment. This device complies
with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. For
product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.
This device and its antenna(s) must not be co-located or operation in conjunction with any
other antenna or transmitter.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.
Table of Contents
AirLive POE-280HD User’s Manual
iii
Table of Contents
1. Overview...................................................................................................1
1.1 Introduction ..........................................................................................1
1.2 Features...............................................................................................1
1.3 Product Specification ...........................................................................2
1.4 System Requirement ...........................................................................3
2. Package Contents and Installation ........................................................4
2.1 Hardware Overview .............................................................................4
2.2 Hardware Installation ...........................................................................6
2.3 Connect to IP Camera .........................................................................9
3. Using IP Camera via Web Browser ......................................................11
3.1 Windows Web Browser......................................................................11
3.2 Mac Web Browser..............................................................................12
4. Operating IP Camera via Mobile Phone ...............................................15
4.1 Mobile Phone Viewing .......................................................................15
4.2 Using IP Camera via iPhone..............................................................16
5. Configuration of Main Menu .................................................................17
5.1 Live View............................................................................................18
5.2 Setting................................................................................................19
5.3 Client Setting .....................................................................................20
5.4 Image Setup ......................................................................................21
6. Setting-Basic..........................................................................................22
6.1 System...............................................................................................22
6.2 Camera ..............................................................................................27
6.3 Network..............................................................................................39
6.4 Security..............................................................................................51
7. Setting-Advanced ..................................................................................55
7.1 FTP Client ..........................................................................................55
7.2 SMTP.................................................................................................60
Table of Contents
AirLive POE-280HD User’s Manual
iv
7.3 Network Storage ................................................................................66
7.4 Memory Card .....................................................................................71
7.5 HTTP Event .......................................................................................75
7.6 Alarm output.......................................................................................78
7.7 Schedule............................................................................................79
7.8 Alarm Input.........................................................................................81
7.9 Alarm Buffer .......................................................................................82
7.10 Motion Detection..............................................................................82
7.11 System Log ......................................................................................84
8. Appendix ................................................................................................85
A. Frame-rate and Bitrate Table............................................................85
B. Storage Requirement Table ..............................................................90
1. Overview
AirLive POE-280HD User’s Manual 1
1
1. Overview
This user’s guide explains how to operate this camera from a computer. User should read
this manual completely and carefully before you operate the device.
1.1 Introduction
The AirLive POE-280HD is a high-end 1.3 -megapixel network camera designed for
professional indoor surveillance and security applications. Megapixel (MP) IP cameras are
now available that offer a huge jump in image quality compared to conventional
surveillance cameras. This new model complements an architecture and software that is
based on variations for professional indoor surveillance and security applications. The
possibility to view video from AirLive IP Cameras over the Internet is only one of the
benefits. AirLive POE-280HD is designed to offer high-performance and is equipped with
PoE port, ensuring to power IP camera and provide network activity via one RJ45 network
cable. This provides an easier installation and lower cable costs and allows placement of
Airlive POE cameras in locations with power limitation. The built-in IR LED and ICR make
POE-280HD provide a clear and smooth video image even in the night time or in a low
illumination environment. For applications such as hallways or stairwell, the POE-280HD is
an ideal IP camera for these locations.
1.2 Features
This manual will illuminate the steps of how to setup and operation this IP camera, so you’ll
also soon be enjoying the benefits of these product features:
UPnP for fast and easy installation
Support 18pcs high illumination LED
1.3 megapixel progressive scan CMOS
Multiple H.264, Motion JPEG and MPEG-4 video streams
Mobile Phone Live Viewing
64 channel surveillance software
IR Night Vision Dome Camera suits various of application
1. Overview
AirLive POE-280HD User’s Manual 2
1.3 Product Specification
Models
AirLive POE-280HD
Image sensor
1/4” Progressive scan CMOS 1.3 Megapixel sensor
Lens
F1.5, 4.0mm Megapixel board lens
Digital Zoom
10x digital
Min Illumination
0 Lux with Night-vision LEDs on
IR working distance
15 M
Video Compression
H.264 / MPEG-4 / Motion JPEG
Resolutions
UP to 1280 x 1024
Frame rate
Motion JPEG: Up to 15 fps at 1280x1024
Up to 30 fps at 640x480
MPEG-4: Up to 15 fps at 1280x1024
Up to 30 fps at 640x480
H.264: Up to 15 fps at 1280x1024
Up to 30 fps at 640x480
Video streaming
Simultaneous Motion JPEG, MPEG-4, H.264 and
3GPP (4 streaming)
Wireless
None
Alarm and event
management
Input: alarm buffer, motion detection
Output: network storage, FTP, SMTP, HTTP event
Pre-and post alarm buffer
Casing
PC+ABS casing
Power
12V DC, 1A, Max 5W
Operating
conditions
Operation: Temp: 0 ~ 50 (32 ~ 122 )
Humidity: 20% ~ 85% non-condensing
Supported
protocols
Bonjour, TCP/IP, DHCP, PPPoE, ARP, ICMP, FTP,
SMTP, DNS, NTP, UPnP, RTSP, RTP, HTTP, TCP,
UDP, 3GPP/ISMA RTSP
Dimension
HxWxD:145x145x100 mm
Approvals
CE, FCC, RoHS
1. Overview
AirLive POE-280HD User’s Manual 3
1.4 System Requirement
For normal operation and viewing of the network camera, it’s recommended that your
system meet these minimum requirements for proper operation:
Item Requirements
CPU Pentium 4 2.8GHz (or equivalent AMD)
Graphic Card 256 MB RAM graphic cards(or equivalent on-board graphic
cards)
RAM 1G
Operating
System
Windows 2000, Windows 2003, Windows XP, Windows Vista,
Windows 7, and Mac OS X Leopard
Web Browser Internet Explore 6 or later
Note: Please keep updating the latest Windows software and service package. (Ex: Net
Framework, Windows Media Player, Enhance ActiveX Security)
2. Package Contents and Installation
AirLive POE-280HD User’s Manual 4
2
2. Package Contents
and Installation
User can find the following items in the package as below:
1. POE-280HD is the main element of the product.
2. Bundle CD include Setup Wizard II, Quick Start Guide, User Manual and other tools
3. Power Adapter dedicates 12V DC electric power output to Network Camera.
4. Quick Start Guide provides important information and instructions for installing this
device.
5. Accessory Package
2.1 Hardware Overview
Inside View
2. Package Contents and Installation
AirLive POE-280HD User’s Manual 5
LED Indicator
Steady orange means SD card ready SD Card Orange
Flashes orange while accessing SD card.
Red Steady red for booting up process; Steady red 30
Seconds when WPS configure failed.
Blue Steady blue for booting up competition.
Purple Flash purple during firmware upgrading.
Power
Unlit When you press reset button.
Back Side View
LED Indicator
Green Steady green for Network link. Network
Orange Flash orange while Network activity.
Reboot Press the Reset Button to reboot the camera. Reset
Reset to
Factory Default
Hold the Reset Button for 10 seconds to restore the
camera to default
2. Package Contents and Installation
AirLive POE-280HD User’s Manual 6
2.2 Hardware Installation
Follow these steps to install the POE-280HD on your Ethernet:
A. Wall mounting and Ceiling mounting
1. Attach the alignment sticker to the wall/ceiling and drill two pilot holes into it.
2. Hammer the supplied plastic anchors into the holes.
3. Align the three holes on the base of camera with the three plastic anchors on the wall
and ceiling, insert the supplied screws to the corresponding hole and screw them.
B. Connect Cables
1. Power over Ethernet (PoE)
Using a standard RJ-45 network cable, connect the IP Camera to a PoE-enabled Hub /
Switch / Router
2. Package Contents and Installation
AirLive POE-280HD User’s Manual 7
2. Without Power over Ethernet (PoE) connection
Connect the power adaptor to the IP Camera. Using a standard RJ-45 network cable,
connect the IP Camera to a normal Hub / Switch / Router.
2. Package Contents and Installation
AirLive POE-280HD User’s Manual 8
C. Adjust the view angle- 3 axis Mechanism Design
1. Turn the lens module right and left to your desired pan position.
2. Turn the lens module up and down to your desire tile position.
3. Turn the lens module to adjust the image orientation to satisfied angle.
D. Completion
1. Clean the dome bubble to remove the dust and finger print.
2. Rotate the black shield on the dome bubble to match the camera’s position.
3. Fasten the dome cover to the base clockwise and make secure two parts reaching the
final position by checking two small dots on the side of housing
4. Slightly adjust dome bubble to final position if needed and double check the camera is
properly focused.
5. The installation is complete now.
2. Package Contents and Installation
AirLive POE-280HD User’s Manual 9
2.3 Connect to IP Camera
A. Insert the bundle CD into your PC/Laptop
B. Auto Run Screen then shows up, click “Install Driver & Utility Æ IP Search Tool” to
install the configuration tool software
2. Package Contents and Installation
AirLive POE-280HD User’s Manual 10
C. After complete installation, run the configuration tool software
D. The Software scans the network and finds the IP Camera, then list in the dialog box.
E. If the Camera’s IP address is in the same IP segment as your LAN, select the founded
IP Camera and double click on the item, then the default browser will show up and
connect to the IP camera’s Web automatically.
3. Using IP Camera via Web Browser
AirLive POE-280HD User’s Manual 11
3
3. Using IP Camera via
Web Browser
3.1 Windows Web Browser
A. Open your web browser, and enter the IP address or host name of the IP camera in the
Location / Address field of your browser.
Note: If you only want to view the video without accessing Setting screen, enter
“http://<IP>/index2.htm” as your web URL.
B. Use the default account “admin” and default password “airlive”.
Note: The default user name “admin” and the password “airlive” are set at the factory
for the administrator. You can change them in the Account Menu. (Please check
“Setting → Basic → Security → Account”)
C. The monitor image will be displayed in your browser. In the far left side of main
configuration are Setting, Client Setting, and Image Setup.
3. Using IP Camera via Web Browser
AirLive POE-280HD User’s Manual 12
3.2 Mac Web Browser
A. Click the Safari icon, and enter the IP address of the IP camera in the Location /
Address field of your browser.
3. Using IP Camera via Web Browser
AirLive POE-280HD User’s Manual 13
Note: If you only want to view the video without Setting screen “http://<IP>/index2.htm”
as your web URL.
B. Enter the default account “admin” and default password “airlive”.
Note: The default user name “admin” and the password “airlive” are set at the factory
for the administrator. You can change them in the Account Menu (Please check
“Setting → Basic → Security → Account”)
3. Using IP Camera via Web Browser
AirLive POE-280HD User’s Manual 14
C. The monitor image will be displayed in your browser. In the far left side of main
configuration are Setting, Client Setting, and Image Setup.
4. Operating IP Camera via Mobile Phone
AirLive POE-280HD User’s Manual 15
4.1 Mobile Phone Viewing
4
4. Operating IP Camera
via Mobile Phone
3G Mobile Phone Streaming Viewing
For 3G mobile phone viewing, type “rtsp://<IP>:<PORT>/video.3gp ” into your 3G
Streaming Link. <IP> is the Public IP address of your IP camera; <PORT> is the RTSP
port of your IP camera (Default value is 554.) Example:
rtsp://100.10.10.1:554/video.3gp
Note: You can also use RTSP clients (RealPlayer, VLC, QuickTime Player…etc.) to
view RTSP streaming, just type in “rtsp://<IP>:<PORT>/video.3gp” as the Player URL
2.5G Mobile Phone WAP Viewing
For 2.5G mobile phone viewing, type “http://<IP>/mobile.wml” into your 2.5G WAP
Browser. <IP> is the Public IP address of your IP camera.
2.5G Mobile Phone Browser Viewing
For 2.5G mobile phone viewing, type “http://<IP>/mobile.wml ” into your 2.5G Web
Browser. <IP> is the Public IP address of your IP camera.
/