Tripp Lite Metered Rack PDU Owner's manual

Brand: Tripp Lite

Model: Metered Rack PDU

Category: Power distribution units (PDUs)

Type: Owner's manual

This manual is also suitable for

Owner’s Manual

1111 W. 35th Street, Chicago, IL 60609 USA

www.tripplite.com/support

Important Safety Instructions

SAVE THESE INSTRUCTIONS

This manual contains instructions and warnings that should be

followed during the installation, operation and storage of this

product. Failure to heed these instructions may affect your warranty.

Important Warnings

• OperatethePDUatindoortemperaturesbetween32°Fand104°F(between0°Cand40°C)only.

• Provideadequateprotectionagainstexcesscurrents,shortcircuits,andgroundfaultsin

 accordancewithlocalandnationalelectricalcode,suchasNECintheU.S.

• ThemainssocketthatsuppliesthePDUshouldbenearthePDUandeasilyaccessible.

• ThePDUprovidesconvenientmultipleoutletsbutitDOESNOTprovidesurgeorlinenoise

 protectionforconnectedequipment.

• ThePDUisdesignedforindooruseonlyinacontrolledenvironmentawayfromexcessmoisture,

 temperatureextremes,conductivecontaminants,dustordirectsunlight.

• DonotconnectthePDUtoanungroundedoutletorextensioncordsoradaptersthateliminatethe

 connectiontoground.

• ThepowerrequirementforeachpieceofequipmentconnectedtothePDUmustnotexceedthe

 individualoutlet'sloadrating.

• ThetotalpowerrequirementforequipmentconnectedtothePDUmustnotexceedthemaximum

 loadratingforthePDU.

• DonotdrillintoorattempttoopenanypartofthePDUhousing.Therearenouser-serviceablepartsinside.

• DonotattempttomodifythePDU,includingtheinputplugsandpowercables.

• DonotattempttousethePDUifanypartofitbecomesdamaged.

• DonotattempttomountthePDUtoaninsecureorunstablesurface.

• Neverattempttoinstallelectricalequipmentduringathunderstorm.

• Useofthisequipmentinlifesupportapplicationswherefailureofthisequipmentcanreasonablybe

 expectedtocausethefailureofthelifesupportequipmentortosignificantlyaffectitssafetyor

 effectivenessisnotrecommended.Donotusethisequipmentinthepresenceofaflammable

 anestheticmixturewithair,oxygenornitrousoxide.

Metered Rack PDUs

Español – p. 8 • Français – p. 15

Warranty

Registration

chance to win a FREE Tripp Lite

product! www.tripplite.com/warranty

Low-Voltage Models: PDUMH15, PDUMH15S, PDUMH20

High-Voltage Models: PDUMH20HV, PDUMH30HV, PDUMH32HV

201103062 93-3059.indd 1 4/29/2011 2:33:39 PM

Installation

Note: The illustrations may differ somewhat from your PDU model.

Determine Installation Configuration.

The PDUs covered by this owner’s manual

supporttheseinstallationconfigurations:2U,

1Uand0Urackmount;wall-mountandunder-

counter. See below for installation

configurations pertaining to your specific

model.Chooseaconfigurationandfollowthe

installation instructions in the appropriate

sectionofStep1beforeproceedingtoStep2.

Note: Regardless of installation

configuration, the user must determine the

fitness of hardware and procedures before

mounting. The PDU and included hardware

are designed for common rack and rack

enclosure types and may not be appropriate

for all applications. Exact mounting

configurations may vary.

1-1

2U Rack Installation. Attach the

includedbracketstothesideofthePDUwith

theincludedscrews(A).Afterinstallingthe

brackets, position the PDU in the rack and

installfouruser-suppliedscrewsthroughthe

unit’sbracketsandintotherackrails(B).

1-2

1U Rack Installation.AttachthePDU

to the rack by inserting four user-supplied

screws (A) through the PDU mounting

brackets(B)andintothemountingholesof

therackrailasshown.

1-3

0U Rack Installation.Part1:Remove

the screws (C) attaching the mounting

bracketstothePDU,changetheorientation

of the brackets as shown and reattach the

brackets. Use only the screws supplied by

the manufacturer or their exact equivalent

(#6-32, 1/4” flat head). Part 2: Attach the

PDU vertically by inserting two or more

user-supplied screws (A) through the PDU

mounting brackets (B) and into mounting

pointsintherackorrackenclosure.

1-4

Wall Installation.AfterrepeatingPart1

above,attachthePDUtoastablemounting

surface by inserting two or more user-

supplied screws (A) through the PDU

mounting brackets (B) and into secure

mountingpointsonthemountingsurface.

1-5

Under-Counter Installation. After

repeatingPart1above,attachthePDUtoa

stable mounting surface by inserting four

user-supplied screws (A) through the PDU

mountingbrackets(B)andintosecuremountingpointsonthemountingsurface.

1-1

1-5

1-4

1-2

1-3

201103062 93-3059.indd 2 4/29/2011 2:33:40 PM

Attach the input plug of the PDU to a grounded

outlet. Insert theplug directlyinto agrounded outlet

thatdoesnotshareacircuitwithaheavyelectricalload

(suchasanairconditionerorrefrigerator).

Note: Select models include an input plug adapter that

converts plug types for various applications. See below

for details.

2-1

NEMA Adapter Connection (Optional -

PDUMH20HV Only):ThePDUMH20HVincludesa

plug adapter that adds a NEMA L6-20P plug to the

inputpowercord.Usethisadapteronlyifyouwillbe

connecting the PDUMH20HV to a NEMA L6-20R

outlet.InserttheIEC60320C19connector

ofthe

adapter into the IEC 60320 C20 connector

of the

input power cord. Secure the connection with the

retention bracket

 by using the included bolts to

fasten the two halves of the bracket around the

connectionasshown.

Caution: To avoid the risk of electric shock, ensure that

the Neutral (L2) conductor has been identified before

connecting the PDU.

2-2

Input Power Cord Connection (PDUMH20HV

Only): InserttheIEC60320C19connector

ofthe

inputpowercordintotheIEC60320C20inlet

ofthe

PDU.Connecttheotherendoftheinputpowercord

to a compatible source ofACpower, such as a UPS

system, PDU or utility outlet. The PDU should be

providedwith over-currentprotection. PDUMH20HV

shouldbeprovidedwithamaximum20Abranch-rated

over-currentprotectiondevice.

Note: The AC power source should not share a circuit

with a heavy electrical load (such as an air conditioner

or refrigerator).

Installation (continued)

2-1

PDUMH20HV

2-2

2-1C

201103062 93-3059.indd 3 4/29/2011 2:33:41 PM

Installation (continued)

Attach equipment to the PDU.Donotexceedthe

load rating of the PDU. The total electrical current

usedbythePDUwillbedisplayedonthedigitalmeter

inamperes.

3-1

3-2

3-3

201103062 93-3059.indd 4 4/29/2011 2:33:42 PM

Features

Input Plug (Varies by Model)

Outlets (Vary by Model): Duringnormaloperation,theoutlets

distributeACpowertoconnectedequipment.

Circuit Breaker: Ifthecurrentdrawnbytheequipment

connectedtothePDUexceedstheMaximumLoadRating,the

circuitbreakerwilltriptopreventpossibledamage.Whena

circuitbreakertrips,itsplungerwillpopup.Disconnectexcess

equipmentandallowthebreakertocoolatleastoneminute

beforedepressingtheplungertoresetthebreaker.

Ammeter: ThetotalelectricalcurrentusedbythePDUwillbe

displayedonthedigitalmeterinamperes.

Grounding Lug: UsethisscrewtoconnectthePDUtoground.

Power Inlet (Select Models):TheIEC-320-C20powerinlet

connectstotheincludedpowercordoracompatibleuser-

suppliedpowercord.Theinletincludesabrackettosecurethe

cordconnection.

Input Plug Adapter (Select Models): Convertsplugtypesfor

variousapplications.

NEMA 5-15P

NEMA L5-20P

NEMA L6-20P/L6-30P

IEC-320-309P

NEMA 5-15R

NEMA 5-15/20R

IEC-320-C13

IEC-320-C19

IEC-320-

C20 INLET

NEMA 5-20P

NEMA L5-20R

NEMA L6-20P

IEC-320-C19

2 7

Thermal 2-Pole Breaker

(PDUMH32HV)

Magnetic, 2-Pole Branch-Rated

Breaker (PDUMH30HV)

201103062 93-3059.indd 5 4/29/2011 2:33:43 PM

Longer 1U Mounting Brackets: Usethesebracketstomountthe1UPDUhorizontallyinastandard

rackorrackenclosure.Themountingdepthcanbeadjustedbyattachingthebracketstodifferent

positionsonthePDU.

Shorter 0U Mounting Brackets: UsethesebracketstomountthePDUina0Urack,wallorunder-

counterconfigurationfor1UPDUmodels.

2U Mounting Brackets: Usethesebracketstomountthe2UPDUhorizontallyinastandardrackor

rackenclosure,orinanunder-counterconfiguration.

Cord Retention Shelves (Optional):WheninstalledonthePDU,theseshelvesprovidesecure

attachmentpointsforconnectedequipmentpowercords.Usetheincludedcabletiestosecurecordsto

theshelf.

Features (continued)

8 9 10 11

201103062 93-3059.indd 6 4/29/2011 2:33:43 PM

Warranty & Warranty Registration

LIMITED LIFETIME WARRANTY

Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects in material

and workmanship for its lifetime. If the product should prove defective in material or workmanship within that period, Seller will

repair or replace the product, at its sole discretion. Service under this Warranty can only be obtained by Buyer delivering or

shipping the product (with all shipping or delivery charges prepaid) to: Tripp Lite, 1111 W. 35th Street, Chicago, IL 60609. Seller

will pay return shipping charges. Call Tripp Lite at (773) 869-1234 before sending any equipment back for repair.

THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE,

ABUSE OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY SET

FORTH HEREIN. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES, INCLUDING

ALL WARRANTIES OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET

FORTH ABOVE; THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES. (Some

states do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation

of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This Warranty gives you

specific legal rights, and you may have other rights which vary from jurisdiction to jurisdiction).

WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate or safe for the use intended. Since

individual applications are subject to great variation, the manufacturer makes no representation or warranty as to the suitability or fitness of these devices

for any specific application.

WARRANTY REGISTRATION

Visit www.tripplite.com/warranty today to register the warranty for your new Tripp Lite product. You'll be automatically entered

into a drawing for a chance to win a FREE Tripp Lite product!*

* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.

Regulatory Compliance Identification Numbers

For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique

series number. The series number can be found on the product nameplate label, along with all required approval markings and

information. When requesting compliance information for this product, always refer to the series number. The series number

should not be confused with the marking name or model number of the product.

WEEE Compliance Information for Tripp Lite Customers and Recyclers (European Union)

Under the Waste Electrical and Electronic Equipment (WEEE) Directive and implementing regulations, when

customers buy new electrical and electronic equipment from Tripp Lite they are entitled to:

 • Sendoldequipmentforrecyclingonaone-for-one,like-for-likebasis(thisvariesdependingonthecountry)

 • Sendthenewequipmentbackforrecyclingwhenthisultimatelybecomeswaste

The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.

201103062 93-3059-EN

201103062 93-3059.indd 7 4/29/2011 2:33:43 PM

Page is loading ...

Tripp Lite Metered Rack PDU Owner's manual

Brand: Tripp Lite

Model: Metered Rack PDU

Category: Power distribution units (PDUs)

Type: Owner's manual

This manual is also suitable for

Download PDF

report

in other languages

français: Tripp Lite Metered Rack PDU Le manuel du propriétaire
español: Tripp Lite Metered Rack PDU El manual del propietario

Tripp Lite Metered Rack PDU Owner's manual

This manual is also suitable for

Tripp Lite Metered Rack PDU Owner's manual

in other languages

Related papers

Other documents