For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
MODEL T23088
ENGINE CLEANING GUN
INSTRUCTIONS
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
Introduction
Specifications
Operation
1.
2.
3.
4. Figure 1
5.
Important: Consult local Disposal Agencies for
the proper disposal of solvent and waste
fluids.
Figure 1.
Increase Fluid
Decrease Fluid
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EYE/EAR INJURY HAZARD!
Wear goggles and NOISH-
approved respirator when
using this tool!
DO NOT EXCEED 90 PSI!
Personal injury could
occur.
EXPLOSION HAZARD!
Do not spray flammable
fluids near and open flame
or ignition source.
LUNG HAZARD!
Always wear a respirator
when using this tool and
use in a well ventilated
area.
Parts breakdown provided for reference only. Not all parts shown are available for purchase.
REF PART # DESCRIPTION REF PART # DESCRIPTION
1 N/A AIR HOSE CONNECTOR 16 N/A FLUID INLET NOZZLE
2 N/A VALVE HEX NUT 17 N/A NOZZLE NUT
3 N/A AIR INLET VALVE 18 N/A CUP LID
4 N/A GUN BODY 19 N/A LID GASKET
5 N/A TRIGGER COMPRESSION SPRING 20 N/A SIPHON TUBE
6 N/A TRIGGER 21 N/A CUP PIN
7 N/A TRIGGER PIN 22 N/A FLUID CUP
8 N/A ADAPTER NUT 23 N/A CUP CONNECTOR
9 N/A WAND CONNECTOR 24 N/A TRIGGER STEM
10 N/A INNER WAND TUBE 25 N/A STEM WASHER
11 N/A WAND 26 N/A O-RING 11 X 1.5MM
12 N/A NOZZLE 27 N/A TRIGGER SEAT
13 N/A ADJUSTMENT THUMB WHEEL 28 N/A O-RING 4 X 2MM
14 N/A AIR CAP 29 N/A TRIGGER CONNECTOR
15 N/A CUP CONNECTOR NUT 30 N/A AIR ADJUSTMENT SCREW
T23088 Parts
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
/
