1. Determine the exact length of track needed for your installation.
3. Using the saw included in your kit, cut the marked piece of track to
achieve the desired total length.
• Please note: the best appearance will be achieved by making a straight clean
90 degree cut to the track. !The end of the track that has been cut will become
one of the ends of the completed track installation."
4. Using the track sections as your template, hold the track to the ceiling
where it is to be installed and mark the holes on the ceiling for drilling.
• Please note: this process will be easier if you have a second person hold up 1
end of the track while marking the holes."
• Using a ¼ inch drill bit, drill the holes in the ceiling at the marked locations
and insert the mounting screw plastic anchors."
5. Install an end cap on the first section of track to be installed. "
• Please note, if your first section of track is being installed tight to an end
wall, be sure to install the end cap here first.
Installing Ceiling Track is easy. Whether the track is needed for privacy, storage, or workspace, Ceiling Track Sets can
be set up in minutes! Instructions for installing your ceiling track can be found below:
STEP 1:
STEP 3:
STEP 4:
STEP 5:
2. Track sections are 6ft or 3ft long. If the final track length needs to be
shortened, mark the track at the desired cutting point. !
STEP 2:
CONTINUED