QUICK ASSEMBLY GUIDE
Training Wheels
Folding Pedals
Handlebars &
Fork
IMPORTANT: Refer to bicycle owner’s
manual for complete installation instructions
and product warnings. Use this insert along
with the bicycle owner’s manual.
Push up until leg CLICKS into place.
Pull down on leg to ensure it is
locked securely.
Ensure Shoulder Clip
is over locking pins
before assembling.
With bike on
ground, push
down on
handlebar
assembly
until it CLICKS
into place.
Pull up on
handlebar
to ensure it
is locked
securely.
Rotate pedals
outward until they
CLICK into place.
Attempt to rotate
pedals back to ensure
they are secure.
Ready 2 Roll | 2 Minute Assembly - additional information
To adjust the training wheels, loosen the
training wheel nuts circled above. Slide the wheel
up or down to the correct position. Re-tighten the
training wheel nuts.
Training Wheel Instructions
To remove training wheels, insert straight-slot
screwdriver under the tension clip (as seen above)
and pull training wheel leg straight down and out.
Repeat for opposite side.
WARNING - Before each ride, make sure both axle
nuts are tight. Also make sure both training wheels
are the same distance from the ground (1/8in
(3.17mm)) and securely attached.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Cube Town Owner's manual
-
DAHON Bike Owner's manual
-
-
HP Velotechnik GrassHopper fx and Operating Instruction And Service Instructions Manual
-
Genesis Children's bike Original Instruction Manual
-
Huffy 21460 Owner's manual
-
-
Schwinn Bicycles Tandem Bicycle Owner's manual
-
Schwinn Bicycles electric bicycle Owner's manual
-
