Legrand XBR-4500 Quick Installation guide

How to Re-Setup Domotz on a Luxul Router

Please note that when performing this update, if Domotz is enabled on the Epic Router, you will need to "Connect" your Domotz

client running on the Epic Router to the Domotz Cloud account.

Until this is completed, the site including the Epic Router will lose monitoring capabilities and will appear 'down' when viewing

from your account on domotz.com or the Domotz app.

When viewing from the Epic Router UI, Domotz will appear as if it is working. It will state status as "Running," and will show

IP and MAC addresses.

To correct this and "Connect" your Domotz client on the Epic Router to the Domotz cloud, please perform the

following simple steps:

1. On the Epic Router UI, go to the "Third Party Software" tab, then "Domotz."

2. Once there, click "Connect."

3. You will then be prompted to enter an email address and password - you MUST use the same account

information that was used to create the Epic Router account originally. (If this information has been forgotten,

please contact Domotz support at: support@domotz.com)

4. After logging in, you will see a "Resume Configuration" page - you should see the Domotz Agent Name, and

pre-populated location information on where the agent is running. Click on "RESUME YOUR AGENT."

5. Domotz will then begin to scan for devices on the network and when completed, will show a "DONE"

button - click "DONE" to finish.

6. You can now log back in to your Domotz account on either domotz.com or the Domotz app, and the

Epic Router will now show "Active."

That's it; you're done! If you have any questions on this process, please call Luxul tech support @ 801.822.5450 option 3.