Attach remaining elastic straps
Layout all parts in preparation for assembly
Long Side
Attach base plates and stretch cables
8
Note: Fasten the rest of the canopy by working
from side to side to get an even fit. If elastic ball
straps are too loose, you can double wrap them
around the pole.
Note: Fasten cables by stretching downward and under
hook in foot
(18)
Medium 2 Tapered Tube
Short 2 Tapered Tube
Long 1 Tapered Tube
Corners R-rid
Corners I-rid
4 Way CornerG
H
J
K
L
I
Canopy
(1)
(34)
(2)
(2)
(2)
Large Spring Button
Small Spring Button
Elastic Ball Straps
Plastic Foot Pad
Pin
Ring
(24)
Assemble center piece for ceiling with
spring buttons
Assemble corners to ceiling structure with
spring buttons
Assemble center piece for ceiling with
spring buttons
Assemble sides connecting to center piece
with spring buttons
Pull canopy over ceiling and fasten corners
with elastic straps
Note: Follow this position (rib-triangle faces inwards).
Note: Place cover over frame while the unit is low
to the ground, secure corners with elastic ball straps,
(see inside corner detail). You will tighten and secure
cover completely after the legs are attached and the
eaves are at arm level.
Note: Tilt the canopy on edge to set up all legs on one side,
then the other.
2 per corner
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
MCE Freedom MRL-MB and MR Elevators User manual
-
King Canopy C81027PC Operating instructions
-
-
Graco 9651 & 9744 User manual
-
Paragon Outdoor GZ634SR Installation guide
-
-
STC GZ734S Installation guide
-
InStep QE100A User manual
-
-
