Unbranded ASE2475 User manual

Installation instructions:

Step 1: Remove stock skid.

Step 2: Inspect bolts, replace if any signs of corrosion or damage.

Step 3: Inspect scraper bar for wear. Replace if worn.

Step 4: If scraper bar is in good condition, set scraper bar to desired height using cardboard or

paintsticks.

Step 5: Install Armorskids. Make sure both skids are sitting flat on ground, and not tipped forward or

backwards.

Step 6: Tighten bolts to specs.

Use and care:

Before each use: You should inspect your skids before each use of the snowblower, to ensure they are

properly adjusted and level.

After each use: After you’ve used the snowblower, take time to wipe down machine and wipe off and

dry each skid. Store machine with scraper bar and skids slightly off ground, and make sure skids are dry

with no snow.

Warranty: 5 year warranty against bending or breakage.