Page is loading ...
A Middleby Company
Job Item#
A Middleby Company
INFRARED CHESSE MELTER
Standard Features
- Schwank infra-red burners adjustable from 9,000 BTU to
25,000 BTU
- 60 second preheat time with no waiting between loads
- Stainless steel front, sides, splasher, and interior cavity.
Aluminized top and rear
- Grid: 27 1/4” wide and 13 1/2” deep
- Mounts on 32” Platinum Range flue riser -no other support
needed
- Ideal for melted-cheese dishes, Mexican foods, casseroles,
au gratin dishes, meringues, omlets and plate warming
- Fully insulated lining
- Warranty: two years on specified operational parts and
one year on labor from date of purchase
(Model PCM-32)
05/03 Printed in USA
Form PCM-32
STANDARD CONSTRUCTION SPECIFICATIONS
Exterior Finish: Exterior and interior surfaces are 430
stainless steel #3 polish. Aluminized steel back and top.
Assembly: Insulated top, bottom, sides and back to retain
heat. Shelf wires are chrome plated, rounded and wrapped.
Two shelf positions with safety locks. One shelf comes
standard with unit. Cheese Melter is serviceable from the
front.
PCM-32 (Sectional Mount Salamander)
Cheese Melter: Mounts on flue riser of a sectional range.
Schwank infrared burner tiles have adjustable BTU’s from
9,000 to 25,000 -depending upon products being heated.
Preheat time is 60 seconds. Front opening is 28” wide and 8
1/2” high.
1100 Old Honeycutt Rd., Fuquay-Varina, NC 27526
www.southbendnc.com
Models:
32" (813)
72"
(1829)
36"
(914)
31" (788)
52-3/4"
(1340)
19-1/4"
(489)
16"
(406)
35-3/4" (908)
16-3/4"
(425)
62-1/4"
(1581)
2-3/4" (70)
Gas Connection
(internal piping to front manifold is an option)
31" (787)
19-1/4"
(489)
16"
(406)
24" (610)
9.25" (235)
40.5" (1030)
INTENDED FOR COMMERCIAL USE ONLY.
NOT FOR HOUSEHOLD USE.
MISCELLANEOUS
UTILITY INFORMATION
Form PCM-32
OPTIONS AND ACCESSORIES
- Minimum clearance from noncombustible construction is
zero, except on top where 12” clearance is required for proper
venting. Minimum clearance from combustible construction is
6” on sides and 6” on rear.
- Install under vented hood.
- Check local codes for fire and sanitary regulations.
NOTICE:
Southbend has a policy of continuous product research and
improvement. We reserve the right to change specifications
and product design without notice. Such revisions do not
entitle the buyer to corresponding changes, improvements,
additions or replacements for previously purchased
equipment.
GAS: This unit has a 1/2” rear gas connection with a male NPT
connector. Minimum supply pressure is 7” W.C. for natural gas and
11” W.C. for propane. Unit requires an external pressure regulator
and shut-off vavle to be ordered separately. If using a flexible hose
gas connection, the I.D. of the hose must not be smaller than the
connector on the unit and must comply with ANSI Z21.69, providing an
adequate means of restraint to prevent undue strain on the gas
connection.
PCM-32
The cheese melter and flue riser assembly is
shown here mounted on a six-burner open top
range with a convection oven base.
T
Stainless steel exterior bottom
Sloped encloser
T
T
Interpiping of gas connection to sectional
range base
Riser assembly for mounting over Sectional
Range
T
THGIEW&SNOISNEMIDETARCGNIPPIHS
ledoMhtdiWthgieHhtpeDemuloVthgieW
23-MCP
63
)419(
72
)686(
22
)955(
tfuc4.21
)muc53.0(
sbl012
)gk3.59(
SAG
ledoM
larutaN
ruoH/UTB
enaporP
ruoH/UTB
23-MCP000,52000,52
/