Press for play/pause
Mi Bluetooth speaker
Switching on/o
Press and hold the multifunction button for 3 seconds
(see the gure), after which you will hear an audible alarm
and see a blue light, which noties about the switching on
of speakers and pair it with other devices via Bluetooth.
Press and hold the multifunction button for 3 seconds,
you will hear a sound and see a blinking blue LED that
indicates the device o.
If you enable a speaker, but do not connect it to other
devices via Bluetooth, the red LED will blink, and after
10 minutes a speaker will automatically switch o. This
feature helps to save energy.
Note: To play music, you rst need to be sure to
connect the speaker to any device. In this device,
you can not adjust the volume of the music, it can
be done only on devices from which you directly
play this music.
Press and hold for on/o
Pairing with smartphone via Bluetooth
1. Put a device in the vicinity of the smartphone, the distance should not
exceed 10 meters.
2. Make sure that the speaker is turned o. Press the On / O button and hold
it for 3 seconds and then starts ashing red light, indicating the start of the
synchronization of devices.
3. Turn on Bluetooth on your phone and start the search for Bluetooth devices.
4. At the end of the search, select «Mi Bluetooth Speaker», after which you
will hear an alarm sound. Thus, you will know that the pairing of devices is
successfully completed.
5. After disconnecting the device from the speakers, you will again hear an
alarm sound. The indicator lights up red and blue, it will indicate that the new
smart phones, or other devices can be connected to a speaker. If you turn
on the device, a speaker can automatically connect to a smartphone or other
device.
Press and hold a button for 3
seconds
Less than 10
meters
xiaomi-mi.com
XIAOMI-MI.COM