Bestron AWH2000 Owner's manual

WINTER WARM

DE

Handleiding

Bedienungsanleitung

Mode d’emploi

FR

NL

EN

Manual del usuario

Instruction manual

Istruzioni per l’uso

IT

ES

50

60

Hz

220

240

Volts

AWH2000

INSTRUCTION MANUAL

1000

2000

Watts

T

O

P

Q

U

A

L

I

T

Y

G

U

A

R

A

N

T

E

Page is loading ...

27

EN

CONGRATULATIONS!

Congratulations with the purchase of this Bestron product. These

instructions tell you how the product works and how to use it. Read

the instructions carefully before you start using the appliance. Only use

the appliance in the manner described in the instructions. Keep these

instructions in a safe place for future reference.

Defects:

If the appliance is defective, do not try to repair it yourself. Always have

a qualified mechanic carry out any repairs.

Children:

• This appliance must be kept out of reach of children under the age of

three, unless they are constantly supervised.

• Children between the ages of 3 and 8 are only allowed to switch

this device on and off, provided that it is firmly secured and installed

in a normal position, and that the children are supervised or have

received instructions on how the appliance works and its safety and

that they are aware of the potential dangers that may occur.

• Children between the ages of 3 and 8 are not allowed to connect or

adjust the appliance.

• Children are not allowed to clean and maintain the appliance.

• Keep an eye on children to ensure that they do not play with the

appliance.

WHAT YOU SHOULD KNOW ABOUT ELECTRICAL APPLIANCES

• Check that the mains voltage corresponds with that shown on the

rating plate of an electrical appliance before you use it.

• Always install electrical appliances on a stable and level surface

where it cannot fall over.

• Certain parts of an electrical appliance may become warm or

sometimes hot. Do not touch them as you may burn yourself.

Particular attention has to be given where children and vulnerable

people are present.

• Make sure your hands are dry when you touch an electrical appliance,

a cord or a plug.

• Electrical appliances must be able to lose their heat to avoid fire

hazards. Therefore, make sure that the appliance has sufficient

clearance around it and that it does not come into contact with

flammable materials. Electrical appliances must never be covered.

• Make sure that electrical appliances, cords or plugs do not come into

contact with water.

28

EN

• Never immerse electrical appliances, cords or plugs in water or any

other liquid.

• Do not touch electrical appliances if they have fallen in the water.

Immediately pull the plug out of the socket. Stop using the appliance.

• Make sure that electrical appliances, cords and plugs do not come

into contact with heat sources, such as a hot hob or open fire.

• Never let cords hang over the edge of the sink, a worktop or a table.

• Always remove plug from the socket when you are not using the

electrical appliance.

• Remove the plug from the socket by pulling the plug itself and not

the cord.

• Regularly check if the cord of the electrical appliance is not damaged.

Do not use the electrical appliance if the cord shows signs of damage.

If the cord is damaged, it should be replaced by the manufacturer, a

technical service provider or a person with an equivalent qualification,

to avoid any danger.

• The appliance may not be switched on with the aid of an external

time switch, or by a separate system with remote control.

WHAT YOU SHOULD KNOW ABOUT THIS APPLIANCE

• Be careful when using the appliance outdoors.

• Never use the appliance in damp or wet locations.

• Thoroughly clean the appliance after use (see Cleaning and

Maintenance).

• Take care that inflammable objects do not get in touch with warm air

of the fan heater.

• Do not insert objects through the grille.

• Use the appliance only in a vertical position.

• Do not place the fan heater directly beneath the wall socket or on

deep ply carpet.

• When installing, allow for a clearance of 25 cm to the side, 20 cm

above the appliance and 180 cm below the appliance.

29

EN

In order to avoid overheating, do not cover the device!

ENVIRONMENT

• Dispose of packaging material such as plastic and cardboard

boxes in the designated containers.

• Do not dispose of this product as normal domestic waste at the

end of its life, but hand it in at a collection point for the reuse of

electric and electronic equipment. Look for the symbol on the

product, the user instructions or the packaging showing the

type of waste.

• The materials can be used as indicated. By helping us

reuse and process the materials or otherwise recycle the

old equipment, you will be making an important contribution

towards the protection of the environment.

• Your municipality can tell you where to find the designated

waste collection point in your neighbourhood.

CE DECLARATION OF CONFORMITY

This product conforms to the requirements of the following European

Directives on safety:

• EMC Directive 2014/30/EU

• Low Voltage Directive 2014/35/EU

• RoHS Directive 2011/65/EU

R. Neyman

Quality control

30

EN

OPERATION - General

The appliance is intended only for domestic use, not for professional use.

1. Display

2. Housing

4. Stand-By switch

5. QuickStart button

3. Ventilation grill

OPERATION - Before first use

Remove the device from the packaging and remove all the packaging materials.

WARNING:

• In order to avoid overheating, do not cover the device.

• The device must not be located immediately below a socket-outlet

OPERATION - Install

The device can be hung up using two screws. The

screws as well as the plugs are included.

Please note that the device can only be installed in

rooms with a minimum height of 220 cm. This means

that the distance between the floor and the bottom of

the appliance must be at least 180 cm. A space of at

least 20 cm must remain free above the device. There

should also be a free space of about 25 cm on either

side of the device.

The distance between the screws must be 32.5 cm.

1. 2. 3. 5.

4.

31

EN

OPERATION - Connect

Model with plug:

Connect the device to the nearest

power outlet. You can also have the

unit connected in a fixed point by an

authorised installer.

Model without plug:

Have the unit connected by (preferably) a

recognised installer in a fixed point.

PROTECTION AGAINST OVERHEATING

This device turns off automatically in the event of overheating. For example, when ventilation is either

partly or completely obstructed. In this case, turn off the device with the Standby switch, remove the object

blocking the vents and wait about 30 minutes for the device to cool. Then switch the device on again with

the Stand-By switch. Please contact customer service if the problem persists.

REMOTE CONTROL

ON/OFF Switches the device on or off

24H Sets the shutdown timer

MODE Switches between Ventilating, Heating and

Rapid heating

LOCK Enables Child Lock mode

AUTO Enables Open-Window Protection

CLOCK Displays the current time

TEMP Sets the temperature weekly timer

TIMER Sets the weekly timer

SET Sets the day and time

POWER-OFF DELAY

When you switch off the device, it will continue to work for a few seconds. This is normal.

OPERATION - Quickstart guide

Standby mode

Before you can operate the device using the remote control, you must put it in standby mode with the

Standby switch.

Ventilation

Switch on the device by pressing the ON/OFF button on the remote control. The appliance will ventilate and

the ventilation light will turn on.

WALL HEATER

blue (N)

brown (L)

PN

32

EN

Warm air

Switch on the device by pressing the ON/OFF button on the remote control. Then press MODE. The device

will provide warm air, 1 heat lamp switches on and the ventilation light switch on.

Hot air

Switch on the device by pressing the ON/OFF button on the remote control. Then press MODE twice. The

device will provide hot air, 2 heat lamps switch on and the ventilation light switch on.

Switch on quickly

To switch the device on quickly with warm air, press the QuickStart button on the back of the device.

OPERATION - Setting the temperature

1. Switch on the device by pressing the ON/OFF button on the remote control.

2. Then press - or + to decrease or increase the temperature.

The first 2 digits on the display indicate the current temperature. The last 2 digits indicate the desired

temperature.

When it reaches the desired temperature, the automatic thermostat ensures that the room stays at the set

temperature. The first 2 digits on the display may occasionally deviate by a few degrees. This is normal.

OPERATION - Using the power-off timer

The power-off timer allows you to set the appliance to switch off automatically after a set time.

1. Switch on the device by pressing the ON/OFF button on the remote control.

2. Press 24H on the remote control.

3. Press 24H again to increase the set time by 1 hour at a time.

The device will switch off automatically after the set time.

OPERATION - Set the current day and time

1. Switch on the device by pressing the ON/OFF button on the remote control.

2. Press SET on the remote control.

3. Then press - or + to set the day of the week.

(Mon = 1, Tue = 2, Wed = 3, Thu = 4, Fri = 5, Sat = 6, Sun = 7).

4. Press SET again.

5. Then press - or + to set the hours.

6. Press SET again.

7. Press – or + to set the minutes.

8. Press SET again.

WARNING:

If you switch off the device with the Standby switch on the back, all settings will be lost. You must then enter

all settings again to use the weekly timer.

OPERATION - Using the timer

With the week timer you can have the device automatically switched on and off at different times every

weekday. Before using the weekly timer, you must set the current day and time. See the above chapter.

1. Switch on the device by pressing the ON/OFF button on the remote control.

2. Press TIMER on the remote control. The display shows the number 1, which means that you can now

set the power-on time for Monday.

33

EN

Setting the power-on time:

3. Press TIMER again.

4. Then press - or + to set the hours.

5. Press TIMER again.

6. Press - or + to set the minutes.

The power-on time is now set. You can now set the power-off time.

Enter power-off time:

7. Press TIMER again.

8. Then press - or + to set the hours.

9. Press TIMER again.

10. Press - or + to set the minutes.

The power-off time is now set. The device will switch off after a few seconds.

The device will now turn on and off at the set times every Monday.

You can also set power-on and power-off times for the remaining weekdays. Then repeat steps 1 and 2, but

then select another weekday using the - and + key. For example, #4 indicates that you wish to set the on

and off times for Thursday.

Then continue with steps 3 to 10. Repeat this for every weekday that you wish to have the device turn on

and off automatically.

When you have finished setting the power-on and power-off times, you can also set the desired temperature

for each weekday.

Setting the temperature for each weekday:

11. Press DELAY. You will see a number (weekday) followed by two numbers (temperature).

12. Then press - or + to decrease or increase the temperature.

13. Repeat steps 11 and 12 to set the temperature for each weekday.

WARNING:

If you switch off the device with the Standby switch on the back, all settings will be lost. You must then enter

all settings again to use the weekly timer.

OPEN-WINDOW PROTECTION

The Open-Window protection ensures that the device switches off automatically if the ambient temperature

drops by more than 3 degrees in a short space of time, for example because a door or a window is open.

This prevents all hot air from evaporating immediately.

1. Press AUTO to activate the Open-Window protection.

2. Press AUTO again to deactivate the Open-Window protection.

CHILD LOCK

The child lock prevents children from changing the settings with the remote control. When the child lock

is activated, almost the entire display turns off and you can no longer operate the device with the remote

control.

1. Press LOCK to activate the child lock.

2. Press LOCK again to deactivate the child lock.

CLOCK

By pressing the CLOCK button on the remote control, the digital display shows the current time. After a few

seconds the display will return to the previous screen.

34

EN

WARRANTY CONDITIONS

Bestron offers a 60-month warranty on this equipment against defects resulting from manufacturing and/or

material errors, subject to the following conditions.

1. No labour or material costs will be charged during this warranty period.

2. Any repairs carried out under the warranty will not extend the warranty period.

3. Faulty parts, or in the event of exchange, the faulty equipment itself, will automatically become the pro-

perty of Bestron.

4. The warranty is valid for the first buyer only and is non-transferable.

5. The warranty is not valid for damage caused by:

• Accidents

• Improper use

• Wear and tear

• Neglect

• Faulty installation

• Connection to a different mains voltage than indicated on the type plate

• Unauthorised changes

• Repairs carried out by unqualified third parties

• Use in violation with the applicable statutory, technical or safety standards

• Careless transport without suitable packaging or other protection

6. Warranty cannot be claimed:

• For damage during transport

• If the serial number of the appliance is removed or changed

7. Items excluded from warranty are:

• Cords

• Lamps

• Glass parts

• Filters

8. The warranty does not entitle the purchaser to compensation for any damage other than replacement

or repair of the faulty parts. Bestron cannot in any event be held liable for any indirect or consequential

losses caused by or in relation to the equipment it has provided.

9. Claims under a warranty may only be submitted to your (online) retailer or directly to the Bestron Service

Department. Never send items without being asked to. We may refuse the parcel and you will be liable

for the costs. Contact us first and we tell you how the appliance should be packaged and sent. Each

claim under a warranty must be accompanied by the relevant receipt.

SERVICE

If an unexpected problem occurs, please contact the BESTRON service department:

www.bestron.com/service

Page is loading ...

v200716-04

BESTRON.COM/WHATSAPP

NEED HELP? CHAT WITH US!

WHATSAPP CUSTOMER SERVICE

Bestron AWH2000 Owner's manual

This manual is also suitable for

Bestron AWH2000 Owner's manual

in other languages

Related papers

Other documents