Babbitt Steam Specialty SWK-1 Installation guide

Hello! I've reviewed the installation instructions for the Safety Cap. This document details the process of installing the safety cap, including how to remove the old cap, affix the safety cap, and secure the wire with provided clamps. I'm here to assist with any specific questions you have about these steps or the included components of the kit.
What is included in the Safety Cap Kit?

How do I install the Safety Cap?

Installation of a Safety Cap Kit

Included in the kit:

Safety Cap

5 feet of wire

2 clips for fastening the wire to the cap

2 clips for fastening the wire to piping

2 screws

Installation of the Safety Cap:

1. Remove the 2 screws that hold the guide

arm to the existing cap.

2. Replace the cap with the safety cap and

secure using supplied screws.

3. Secure the wire with 2 clamps as shown.

Screws

Guide

Arm

Safety

Cap

Wire secured

to piping