Tractor Supply SP6BDK Snow Pusher Back Drag User manual

Hello! I've reviewed the installation instructions for the Snow Pusher Back Drag, models SP6BDK, SP7BDK, and SP8BDK. This document provides a step by step guide for attaching the back drag kit to your snow pusher. It includes information on the tools needed, hardware provided, and the proper alignment for installation. I'm ready to answer your questions about this process.
What tools are needed for the back drag installation?

How many bolts and nuts are included in the kit?

Where does the back drag get placed on the snow pusher?

SP6BDK | SP7BDK | SP8BDK

For more information and questions, contact

your local dealer.

SNOW PUSHER

BACK DRAG

INSTALLATION

2

1. Remove the back drag kit from the pallet and

make sure you have all hardware.

2. Place the back drag on the snow pusher and align

the holes.

3. Once aligned, start on one side, and insert 3 bolts

and 3 nuts.

4. Repeat same process for other side.

5. Go back and fully tighten all 6 bolts.

ASSEMBLY

TOOLS REQUIRED

• 15/16” wrench

• 15/16” socket

HARDWARE INCLUDED

• 6 – 5/8” x 2” bolts

• 6 – 5/8” x 2” lock nuts

NOTE: If you have a Snow Pusher without

holes, pre-drilled to accept the back drag,

place the back drag kit on the Snow Pusher to

align and then pre-drill the holes. Make sure

the back drag is parallel to the ground and

the distance between the bottom of the back

drag and the skid shoe is approx. 26” (for 7’

and 8’ Snow Pushers)

NOTE: Back drag will be placed on the outside

of the frame of the snow pusher.

NOTE: DO NOT fully tighten.

4000380 REV1 120321

/

Other documents