2. Mount-It!
  3. MI-7856

Mount-It! MI-7856 Operating instructions

  • I've reviewed the assembly instructions for the Wire Shelving Cart / Printer Stand MI-7856. This document provides a step-by-step guide on how to assemble the three-tiered unit, including attaching casters and positioning the shelves. I'm ready to assist with any questions you might have about the assembly process or its components.
  • How do I attach the casters?
    How do I adjust the shelf height?
    What is included in the hardware packs?
ASSEMBLY INSTRUCTIONS
Visit mount-it.com for product registration and warranty information.
Contact us at [email protected] for support and questions.
1 of 5
Mount-It!
• • •
Mount-It!
Wire Shelving Cart / Printer Stand
(MI-7856)
A
C
D
B
(4)
(24)
E
F
(2)
(2)
(2)
G
2 of 5
Mount-It!
Half-Sleeve
PARTS LIST
A
B
C
CODE DESCRIPTION QTY
1
2
Top with Frame
Lower Shelf
Post 4
HARDWARE PACK 1
Non-Locking Caster
Qty. 2
Locking Caster
Qty. 2
Caster Wrench
(not shown)
E F
HARDWARE PACK 2
D
Qty. 1
Qty. 24
1
3
C
F
E
C
B
CONNECTED HALF-SLEEVES
3 of 5
Mount-It!
Attach the casters to the bottom of the posts.
Place the Locking Casters on the accessible side
of the cart.
2(2 per assembled post)
(x4) D
C
D
Large End
Ridge
Groove
Small End
Connect the half-sleeves at the desired height for the
lower shelf. Use lowest grooves for maximum capacity.
Insert the posts into the corners of the lower shelf.
4
5
B
D(2 per assembled post)
4 of 5
Mount-It!
CONNECTED HALF-SLEEVES
Press the lower shelf firmly to
position it in place.
Press the middle shelf firmly
to position it in place.
Connect the half-sleeves at
the desired height for the
middle shelf.
6D(2 per assembled post)
A
5 of 5
Mount-It!
Press the top firmly to
position it in place.
CONNECTED HALF-SLEEVES
/