2. RPB
  3. T200

RPB T200 Installation guide

  • Hello! I've reviewed the Installation Guide for the GVS|rpb T200, which details the process of placing the head suspension or bump cap air duct into the hood. The document covers steps for inserting the head suspension, connecting the air duct, and aligning the lens. I'm ready to answer your questions about the installation.
  • How to insert head suspension assembly into the hood?
    How to insert the air duct?
    How to align lens tabs with clips?
Form # 7.20.351 Rev: 2
See the T200 Instruction Manual for more information. Available for download at gvs-rpb.com
T200®
Insert the head suspension or bump cap
assembly into the hood.
PLACING THE HEAD SUSPENSION/BUMP CAP AIR DUCT INTO THE HOOD
FIGURE 1.1 FIGURE 1.2
Insert the threaded inlet of the air duct into
the black rubber seal on the back of the
hood. Starting from the bottom side, stretch
the rubber seal over the retaining rib behind
the threaded section.
1
1
2
2
Repeat the steps for the other side.
1
1
2
2
FIGURE 1.3
Line up the tabs of the lens with the clips on
the sides of the lens mount.
- Hook point 1 under point 1 as pictured.
- Snap point 2 over point 2 as pictured.
FIGURE 1.4
/