Grid Frame Installation Instructions - UC120 Bracket
Rev 0715
Bits Required:
Phillips & #25 Torqs
The easiest way to install these UC120
brackets is by loosely attaching the screw
UZSCREWW through the bracket and into
nut UZNUTA so that the end of the screw is
no more then flush with the back of the nut.
Do this with all 4 screws as shown in Figure
A.
Install the UZNUTA's into the two slots in the
bottom rail of the Spine wall Grid frame
placing UC120 so that the bend is aligned
with Mid Cap and secure in place. Align the
other weld nuts to be able to slide into the
ajoining bottom rail of the
screws to hold in place as
shown in Figure B.
Remove screws in Top caps of Grid Frames
and set Top caps aside which will later be
installed after electrical and tiles are installed
in all frames. Next place UC120TC in
position as shown in Figure C. Fasten with
UZSCREWU through hole at top of Mid cap
of frame into the hole in one the tab of the
UC120TC. Flush cap to top of the Mid cap
frame and tighten screw.
Figure A
Figure B
Figure C
Mid
Cap
Top Cap
UC120 PARTS KIT
QTY DESCRIPTION
3
12
12
3
1
1 /Order
UC120 Base
UZSCREWW
UZWNUTA
UZSCREWU
UC120TC
JX INSTRUCTION
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Trane ADX1B040A9H21B Installer's Manual
-
Trane DX1D120A9601A Installer's Manual
-
Trane UC1D120A9601A series Installer's Manual
-
-
-
-
-
-
-
Stratco Good Neighbour Installation guide