2. Koala Kare
  3. 777-XX-KIT

Koala Kare 777-XX-KIT Operating instructions

  • Hello! I've reviewed the Infant Seat Mesh Replacement Instructions for the Koala Kare ISKM. This document provides a detailed step-by-step guide on how to safely remove the old mesh and install a new one using the included aluminum rods. I'm ready to answer your questions about the contents of this manual and the replacement process.
  • What items are included in the replacement kit?
    How do I remove the old mesh?
    How should I position the new mesh when reassembling?
    What is the purpose of the aluminum rods?
Items Included:
One Replacement Mesh
Two 1/4” Aluminum Rods
Removing the Mesh
1. Unbuckle and remove the strap by passing
through the strap holders on both sides.
2.
Partially close the unit so that the mesh is
slack. Pull one end of the nylon away from the
frame.
3. An aluminum rod is inside this part of
the nylon.
To remove, locate the unstitched
opening, approximately
2.5” from the end of
the material. Carefully slide the rod through
this opening and remove.
4. Pull the nylon loose through the frame and
retaining bar. Remove the aluminum rod on the
other side by repeating steps 2 and 3. Discard
old mesh and rods.
INFANT SEAT KRADLE (ISKM)
REPLACEMENT MESH INSTRUCTIONS
P/N 777-XX-KIT
Koala Kare Products ǁ 6982 S Quentin St. ǁ Centennial, CO 80112 Toll Free: 888.733.3456 ǁ 303.539.8300 ǁ Fax: 303.539.8399
www.koalabear.com
P/N 425 May 2012
Strap
Holder
Aluminum
Rod
Retaining
Bar
BW HALFTONE
INFANT SEAT KRADLE (ISKM)
REPLACEMENT MESH INSTRUCTIONS
P/N 777-XX-KIT
Koala Kare Products ǁ 6982 S Quentin St. ǁ Centennial, CO 80112 Toll Free: 888.733.3456 ǁ 303.539.8300 ǁ Fax: 303.539.8399
www.koalabear.com
Reassembling the Mesh
1. Pictograph of the Koala logo should face
inward. Feed nylon between the frame and the
retaining bar.
2. Locate the opening in the end of the nylon,
approximately 2.5” inward. Take one of the
aluminum rods supplied and slide this through the
opening assuring the aluminum rod is no longer
visible.
3. Pull the nylon from the inside so that the
now encased rod fi ts snugly between the retaining
bar and metal frame. Repeat steps with the
remaining rod on the other side.
4.
Check that the rods are snuggly holding the
mesh in place by pressing on the center of the
mesh when the unit is fully open.
Feed the straps
back through the strap holders
and snap the
buckle together.
P/N 425 May 2012
BW HALFTONE
/