RESIN FACTS AND CARE
Our resin soaker tubs and sinks are cast in a
joint-free mold using a polyester-aluminum
trihydrate blend material that hardens to a
solid surface. Resin’s non-porous surface
naturally resists stains, scratches and
discoloring. Sometimes referred to as
“man-made stone”, its extreme durability
helps to preserve its silky matte finish. This
versatile material also allows more freedom
of design since it can be cast into countless
shapes and forms.
Care and Maintenance
Clean water will remove most dirt from your resin tub. Use only mild
cleansers that are safe for painted surfaces when necessary. Do not use
abrasives, acids or ammonia. Wipe dry after each use to retain original
beauty.
Small Scratch Repair:
If a minor scratch should occur, rinse
any dirt from surface with clean water
and rub in small circular motions
using #800 grit sandpaper until scratch
disappears. Follow with #1200
sandpaper to smooth area. Dry with
a soft towel and finish by polishing
with automobile polish.
Barclay Products Limited ▪ 4000 Porett Drive ▪ Gurnee IL 60031 ▪P800-446-9700 ▪F847-244-1259 ▪ www.barclayproducts.com
/
