3.) Turn (Part A) BED Upside down.
4.) Attach FRONT AXLE BRACE (PART L) to
BOTTOM SUPPORT (PART H) middle bar.
5.) Attach STEERING CONNECTOR (PART J) ends to
REAR AXLE SUPPORT (PART E) using M8X16 HEX
BOLT, M8 WASHER, and M8 NYLON NUT (PART Q, Y
and T)
6.) Attach STEERING CONNECTOR (PART J) two-
hole flat side to BOTTOM SUPPORT (PART H). Other
end will attach to middle of the FRONT AXLE BRACE
(PART L). (Do not secure yet)
7.) Attach YOKE (PART K) short side, to middle bolt of
FRONT AXLE BRACE (PART L) with COTTER PIN
(PART U). Place long side of YOKE (PART K) onto
FRONT AXLE BRACE and STEERING CONNECTOR
(PART J).
8.) Attach STEERING CONNECTOR (PART J) ends to
AXLE SUPPORT (PART E) using M8X16 HEX BOLT,
M8 WASHER, and M8 NYLON NUT (PART Q, Y and T)
9.) Attach STEERING CONNECTOR (PART J) two-
hole flat side to BOTTOM SUPPORT (PART H). Other
end will attach to middle of the FRONT AXLE BRACE
(PART L). (Do not secure yet)
10.) Attach YOKE (PART K) short side, to middle bolt
of FRONT AXLE BRACE (PART L) with COTTER PIN
(PART U). Place long side of YOKE (PART K) onto
FRONT AXLE BRACE and STEERING CONNECTOR
(PART J).
11.) Attach YOKE (PART K) short side, to middle bolt
of FRONT AXLE BRACE (PART L) with COTTER PIN
(PART U). Place long side of YOKE (PART K) onto
FRONT AXLE BRACE and STEERING CONNECTOR
(PART J).