8004698, 8004700, 8004702, 8004703, 8004705, 8004706, 8004714, 8004714, 8004715

V 1.3V 1.34

For any technical questions, please call 1-800-665-8685

1

SPECIFICATIONS

8004698 8004700 8004702 8004703 8004705 8004706 8004709 8004714 8004715

Max. Capacity: 800 lb 1,200 lb 1,400 lb 1,800 lb 2,500 lb 600 lb 1,200 lb 1,000 lb 2,000

Rope dia.: 3/16" 5/16" 5/16" 5/16" 7/16" 5/32" 3/16" 2" 2"

Drum capacity: 40 ft 30 ft 20 ft 58 ft 30 ft 33 ft 33 ft 23 ft 23 ft

IMPORTANT SAFETY PRECAUTIONS

WARNING! Read and understand all instructions before using this winch. Keep this manual for the

safety warnings and precautions, operating, inspection and maintenance instructions. When using

this winch, basic precautions should always be followed to reduce the risk of personal injury and/or

damage to the equipment.

PERSONAL SAFETY

1. Do not over reach; keep proper footing and balance at all times. Proper footing and balance enables better control of

the winch in unexpected situations.

2. Dress properly, wear protective equipment. Do not wear loose clothing or jewelry as they can be caught in moving

parts. Tie back long hair. Protective clothes and non-skid footwear are recommended when working.

2. Maintain your winch with care. Keep your winch clean and in good condition for a better and safer performance. The

handle must be kept clean, dry and free from oil and grease at all times. A properly maintained winch reduces the risk of

injury and is easier to control. Applying excessive force can lead to slips, damage to the winch or personal injury.

SERVICE

1. Check for damaged parts. Before using any winch, any part that appears to be damaged should be carefully checked

to determine that it will operate properly and perform its intended functions. Check for alignment and binding of moving

parts; broken parts or mounting xtures, or any other condition that may affect proper operation. Any part that is

damaged should be properly repaired or replaced by a qualied technician.

Hand

Winch

3. Do not overload the winch. For loads over the specied maximum, use a more powerful model.

5. Never winch wire with less than 5 turns of wire rope around the winch drum. The rope fastener may not be able to

withstand the full load.

6. Avoid continuously pulling from extreme angles. This will cause the rope to pile up on one end of the drum, which

could jam the winch and cause damage to the winch or the rope.

7. Be sure to correctly attach the winch before starting to recall the rope.

8. When moving a load, slowly wing the rope until it becomes taut, then stop and check that the rope is correctly

winding before proceeding further.

9. It is recommended to lay a heavy blanket over the cable near the hook end when pulling heavy loads. If a cable

fails and snaps, the cloth will help prevent the cable from whipping out of control.

13. Never release the rope while it is under load.

14. After you have nished operating the winch, release the load and recall the remaining rope.

15. Inspect the rope before each use to make sure it is not frayed or broken.

16. Use caution when pulling or lowering a load up and down a ramp or incline. Keep the path clear and do not let

anyone stand beneath the load being pulled, they could get seriously hurt if the cable should break or the load should

slip.

INSTALLATION

Mount the winch properly, make sure the cable does not have to go over the drum to reach the load you wish

to pull.

OPERATION

1. Periodically check to make sure the winch is properly installed on it's surface.

2. Check the cable to make sure it is not dirty, frayed or damaged.

REPLACING THE ROPE

1. Always replace a cable with one that is identical in diameter and load limit.

2. Unwind the rope from the drum, then remove completely and dispose of it accordingly.

3. Insert the new cable on the drum. Make sure to insert it in the correct manner secure it tightly.

8004698, 8004700, 8004702, 8004703, 8004705, 8004706, 8004714, 8004714, 8004715