01/06
970 Series
Model
8550 Hansen Road • Houston, Texas 77075 • (Ph) 713.943.0688 • (Fx) 713.944.9445 • www.amesrewater.com
MODULATING FLOAT VALVE with
PRESSURE SUSTAINING FEATURE
979-20
679-20
Operation
The AMES Model 979-20 / 679-20 Modulating Float Control Valve with Pressure Sustaining Feature is
designed to automatically maintain a constant liquid level in a tank or reservoir. It is controlled by a remote
mounted Modulating Float Pilot designed to: 1) Modulate Open (allowing uid out of the main valve cover
chamber) when reservoir level decreases, and, 2) Modulate Closed (allowing uid to ll the main valve
cover chamber) when reservoir level increases. A decrease in reservoir level causes the valve to modulate
towards an open position, allowing reservoir level to increase. An increase in reservoir level causes the
valve to modulate towards a closed position, allowing reservoir level to decrease.
The normally closed sustaining pilot remains open when upstream pressure is above the adjustable setpoint,
and modulates toward a closed position if upstream pressure falls below the setpoint. As the sustaining pilot
closes, uid is directed into the main valve cover chamber, allowing the valve to modulate toward a closed
position, raising upstream pressure. Normal level control operation resumes when upstream pressure is
above the sustaining pilot setpoint.
If desired, the modulating action of the valve can be “reversed” by inverting or “reversing” the action of
the Modulating Float Pilot. The Modulating Float Control is remotely mounted from the valve, and eld
connected with 3/8” minimum copper tubing in accordance with factory piping schematic.
Installation Guidelines
• Prior to installation, ush line to remove debris.
• Install valve horizontally “in line” (cover facing up), so ow arrow matches ow through the line. Avoid
installing valves 6” and larger vertically. Consult factory prior to ordering if installation is other than
described.
• Install inlet and outlet isolation valves. NOTE: When using buttery valves, insure disc does not contact
control valve. Damage or improper valve seating may occur.
• Provide adequate clearance for valve servicing and maintenance.
• Install pressure gauge to monitor valve inlet pressure.
• Connect Modulating Float Control to main valve using 3/8” diameter minimum copper tubing (eld
installed) in accordance with factory piping schematic.
• Modulating Float Control should be mounted in a eld installed “stilling well” for protection against surface
turbulence and interference.
Other AMES Float Control Valves
972 / 672 On-Off Float Control Valve (4” & smaller)
972-19 / 672-19 On-Off Float Control Valve (6” & larger)
972-20 / 672-20 On-Off Float Control Valve with Pressure Sustaining Feature
979 / 679 Modulating Float Control Valve
979-15 / 679-15 Modulating Float Control Valve with Solenoid (On-Off) Feature
-
1
Ames Fire & Waterworks 979GS-20 Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Ames Fire & Waterworks 972GD-20,972GS-20 Installation guide
-
-
-
Ames Fire & Waterworks 986GS Installation guide
-
-
Ames Fire & Waterworks 984GS Installation guide
-
-
Ames Fire & Waterworks 985GS-20 Installation guide
-
-
Other documents
-
Watts 920GS-01-15,LF920GD-01-15 Installation guide
-
-
-
Reznor ADFH User manual
-
Lochinvar 000 through 2 User manual
-
-
-
-
Carrier 19DG User manual
-
Trane IntelliPak Installation, Operation and Maintenance Manual