Danfoss Operator Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Danfoss Operator Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
INSTRUCTIONS
4
6
7
013R9223
02/2008 VI.33.V4.22
Mounting on convector
with Danfoss RA 2000 valve
Installing operator through
conduit
with Danfoss RA 2000 valve
Operator with combined remote mounted sensor and dial
1
3
2
4-5 ft
5/64"
Radius min.10"
8
5
013R9223
1
2
8
4
3
6
5/64"
5
7
DANFOSS INC.
7941 Corporate Drive,
Baltimore MD 21236 USA
tel: 410-512-0266
DANFOSS INC.
6711 Mississauga Road, Suite 410
Mississauga, ON, L5N 2W3 CANADA
tel: 905-285-2050
www.na.heating.danfoss.com
/1 inch
INSTRUCTIONS
1
2
3
1
2
3
4
5
4
3
2
1
Limiting and
blocking
the setting range
Upper limit setting (max. setting)
Lower limit setting (min. setting)
Locking setting
is done by combining the upper &
lower limiter settings
STOP
STOP
1
1
2 4
If this operator is being installed on a
RAV, VMT or KOVM valve, it is
necessary to replace the pre-
attached small socket with the large
socket included in product package.
If this operator unit is being installed
on a RA valve fitted with a RA to RA
2000 adapter (013G8070), the socket
spring must be replaced with the
gray spring from the large socket
included in the product package.
3
2 3
Gray spring
5/64"
Small Socket
Small Socket
Large Socket
Small Socket
Small Socket
Large Socket
Gray spring from
large socket
3/16" (34 mm) OD
RAV/VMT/KOVM valves have a larger operator
connection than RA 2000 valves.
/