Kicker 46MPGREM/AMP Owner's manual

46MPGREM/AMP

Compatible with 19417163/19418459

NOTE: AMPLIFIER AND CONTROLLER MUST BOTH BE REPLACED. CONNECTING A NEW

AMPLIFIER TO A BAD CONTROLLER WILL DAMAGE THE NEW AMPLIFIER.

Find the in-line fuse in the trailer connector T-harness and remove fuse. This will be located near the

receiver hitch under the truck. Fig. 1

46MPGREM/AMP-20200222

Rear of vehicle

Fuse Holder

Fig 1

Remove the six T30 bolts and the four T20 screws securing the speaker baffle. Fig. 2

Rotate the speaker baffle onto the tailgate slowly making sure not to create any tension on wiring.

Find the amplifier and disconnect all wiring. The main harness has a release tab on the bottom that needs

to be pressed. The controller cable has a locking mechanism that has to be unscrewed counterclockwise

in order to disconnect the controller cable.

Once all connectors are disconnected, unscrew the four Phillips screws securing the amplifier to the

amplifier bracket and

remove the amplifier from

the tailgate. Fig. 3

Install replacement

amplifier and reconnect

wiring.

Fig 2

Fig 3

Cut the cable tie securing the controller cable to the controller mounting bracket.

Remove the controller from the mount by using a pick tool or small straight screwdriver. Insert the tool as

shown and rotate the tool toward the center of the controller while pushing the controller down slightly.

Repeat for the other side of the controller and remove controller from bracket. Fig.4

Install new controller. Secure the controller cable with a wire tie as it was originally.

NOTE: The controller bracket is glued to the speaker baffle from the factory to reduce rattles. If the

bracket should become loose in the process of replacing the controller, it can be fixed using a small

amount of silicone. Avoid using cyanoacrylate type adhesives as they may cause discoloration on the

front side of the speaker baffle.

Re-install speaker baffle in reverse order and re-install fuse.

NOTE: Be careful not to overtighten the small screws that secure the speaker baffle. These screws

should only be hand-tight.

P.O. Box 459 • Stillwater, Oklahoma 74076 • USA • (405) 624–8510

Fig 4